User manual JOHN LEWIS JLWD1406

[. . . ] JLWD 1406 1400 spin washer-dryer Instruction manual 30 Minute wash Spin Drain Softeners Rinse Soak 30° Cold 30° 40° Delicates 30° Delicates 40° Cottons Off 90° Economy 60° 60° Economy 40° 40° 30° Drying 60° Economy 40° 40° Easy iron 40° Drying 1400 900 700 500 None Programme time Extra dry Store dry Iron dry Prewash Wash Rinse Rinse hold Drain Spin Drying End Spin Synthetics Prewash Quick Extra Automatic Time dry rinse dry Delay start Start/ Pause Wool JLWD1406 Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before use or installation by a qualified person. [. . . ] Pour 1/2 a measure of detergent into the dispenser drawer and start the machine. WASHING 6 KG OF WHITE COTTON AT 90°C 4. Switch the machine on Turn the selector dial to the the desired position to switch the machine on. To switch the appliance off turn it to "Off". Suppose you have 6 kg of laundry to wash. It is white cotton and is suitable for high temperature washing. Open the door. Place the laundry in the drum, one item at a time, shaking them out as much as possible. Select the desired programme/temperature Turn the selector dial to 90° programme. The lights relevant to the phases that form the programme will light up. The display will show the duration of the selected programme, calculated on the basis of the maximum load for each type of fabric. The Start/Pause button light will start flashing. If the load of laundry to be washed is small, at the beginning of the cycle the display will still indicate the duration relevant to the maximum load. The duration value will be gradually adjusted during the cycle. Prewash Wash Rinse P0004 2. Measure out the detergent Pull out the dispenser drawer until it stops. Measure out the amount of detergent required and pour it into the main wash compartment . If you wish to carry out the prewash or a soak programme, pour detergent into the appropriate compartment marked . 2. 05 Synthetics 1. Load the laundry 30 Minute wash Spin Drain Softeners Rinse Soak 30° Cold 30° 40° Delicates 30° Duvets 40° Wool Cottons Off 90° Economy 60° 60° Economy 40° 40° 30° Drying 60° Economy 40° 40° Easy iron 40° Drying Rinse hold Drain Spin Drying End 3. Measure out the fabric softener If required, pour fabric softener into the compartment marked , without exceeding the «MAX» mark. If your laundry needs a soak time, turn the programme selector dial to "Soak 30°" and then, before starting a washing cycle, empty the water as described in the "Soak 30°" paragraph. C0111 C0112 6. Select the spin speed or the "None" option Press the "Spin" button repeatedly button in order to select the desired spin speed or the "None" option. If you select the "None" option, all the spinning phases are suppressed. Close the drawer gently. 16 The relevant light will light up. 1400 900 700 500 None 9. Start the programme Press the "Start/Pause" button. The relevant light will stop flashing, and only the light relevant to the phase that is in progress will remain lit. If you have chosen a delayed start, the washer dryer will begin the countdown. The display will show the duration of the programme or the selected delay. Spin 7. Select the desired options If your laundry is very dirty, it may be advisable to select the "Prewash" option. If your laundry is only slightly soiled, select the "Quick" option. If you wish the laundry to undergo an extra rinse, select the "Extra Rinse" option. [. . . ] In any case the door can be opened only when the door locked light has gone out. Spinning starts late or the machine does not spin The electronic balance control device has cut in because the laundry is not evenly distributed in the drum. The laundry is redistributed by reverse rotation of the drum. This may happen several times before the unbalance disappears and normal spinning can resume. If, after few minutes, the laundry is still not evenly distributed in the drum, the machine will not spin. [. . . ]