User manual JONSERED CS 2153 C

[. . . ] CS 2152 CS 2153 Operators manual English Please read the operator's manual carefully and make sure you understand the instructions before using the machine. KEY TO SYMBOLS Symbols on the machine: WARNING!Careless or incorrect use can result in serious or fatal injury to the operator or others. Please read the operator's manual carefully and make sure you understand the instructions before using the machine. Symbols in the operator's manual: Switch off the engine by moving the stop switch to the STOP position before carrying out any checks or maintenance. Always wear approved protective gloves. Always wear: · Approved protective helmet · Approved hearing protection · Protective goggles or a visor Regular cleaning is required. Visual check. [. . . ] Once the machine has started the valve will automatically return to its original setting. ! WARNING!Note the following before starting: The chain brake must be engaged when the chain saw is started to reduce the chance of contact with the moving chain during starting. Never start a chain saw unless the bar, chain and all covers are fitted correctly. Otherwise the clutch can come loose and cause personal injuries. Make sure you have a secure footing and that the chain cannot touch anything. Keep people and animals well away from the working area. Warm engine Use the same procedure as for starting a cold engine but without setting the choke control in the choke position. The correct choke/start throttle setting is obtained by moving the choke control to the choke position and then pushing it in again. Cold engine H Starting: The chain brake must be engaged when the chain saw is started. Activate the brake by moving the front hand guard forwards. Starting Ignition; choke: Set the choke control in the choke position. This should automatically set the stop switch to the start position. Grip the front handle with your left hand. Hold the chain saw on the ground by placing your right foot through the rear handle. Pull the starter handle with your right hand and pull out the starter cord slowly until you feel a resistance (as the starter pawls engage) then pull firmly and rapidly. Never twist the starter cord around your hand. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine. H Start throttle: The correct choke/start throttle setting is obtained by moving the control to the choke position. Primer bulb: If the machine is fitted with an air purge (A): Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. Push in the choke control as soon as the engine fires and keep pulling until the engine starts. When the engine starts, quickly apply full throttle; the throttle start lock will automatically disengage. English ­ 19 STARTING AND STOPPING As the chain brake is still engaged the speed of the engine must be set to idling as soon as possible, this is achieved by quickly disengaging the throttle lock. This prevents unnecessary wear to the clutch, clutch drum and brake band. · Observe your surroundings and make sure that there is no risk of people or animals coming into contact with the cutting equipment. Note!Reactivate the chain brake by pushing the front hand guard back towards the front handle. The chain saw is now ready for use. · Always hold the saw with both hands. The right hand should be on the rear handle, and the left hand on the front handle. [. . . ] Sharpen the chain and check its tension and condition. Check the drive sprocket for excessive wear and replace if necessary. Check that the stop switch works correctly. Check that there are no fuel leaks from the engine, tank or fuel lines. [. . . ]