User manual JOTUL F 600

[. . . ] These instructions must be kept for future references. Safety notice: If this solid fuel room heater is not properly installed, a house fire may result. For your safety, follow the installation directions. Contact local building or fire officials about restrictions and installation inspection requirements in your area. [. . . ] If the carbon and fly ash are allowed to remain on the glass for an extended period of time it could eventually cause the glass to become etched and cloudy. Any creosote, which might deposit on the glass, should burn off during the next hot fire. the proper cleaning procedure is as follows: 1. Only use a cleaner that is specifically designed for this purpose. The use of abrasives will damage the glass and ultimately leave the glass frosted. Rinse and dry glass completely before burning your stove. Never operate the stove with a cracked or broken glass panel. Always operate the doors slowly and cautiously to avoid cracking or breaking the glass. Never use the door to push wood into the firebox. If the glass becomes cracked or broken follow this procedure for replacement: 1. Carefully remove all of the glass clips from the inside of the door. Like your car, regular maintenance prolongs the life of your stove. The following procedures do not take long and are generally inexpensive, but when done consistently, increase the life of your stove and in turn, increase your years of enjoyment. At least once a year you should perform the following maintenance procedures: 1. Enamel surfaces should be cleaned with soap and water. Only use a vacuum for this job if the vacuum is specifically designed for ashes. Inspect the stove: Using a strong light inspect the stove inside and out for cracks or leaks. Replace all cracked parts and repair any cement leaks with furnace cement. Many accessories have been manufactured for use with the Jøtul F 600. Only use accessories that are specifically designed for the Jøtul F 600. The Jøtul F 600 has been approved for use as an open fireplace, with front doors open. This feature is especially nice when the ambience of a fire is desired. [. . . ] To remove, unfasten the screw and remove the burn plates. Painted products may change color after several years usage. The surface should be cleaned and brushed free of any loose particles before new Jøtul stove paint is applied. Enamelled products must only be cleaned with a clean, dry cloth. [. . . ]