User manual JOYTECH AV CONTROL CENTER 245C

[. . . ] Once a device has been connected there is no need to remove any of the cables when selecting an input. Figure 2 shows a typical AV set up using the Control Center 245C. figure. 2 (Note: The devices connected in this illustration are for reference only. Any suitable device may be connected to the Input Channels. ) DVD/HD DVD Player Camcorder Digital camera Video Game Systerms Cable/Satellite VCR MP3 Player PC/Mac TV 4 english which cable do I use? Depending on the type of output available from your AV device, use the most suitable cable connection from the 'Input Connection Table' below. [. . . ] Save the setting by pushing the Set Button. *When set to AUTO the backlight will remain on for 10 seconds after the user changes the Input Channel or adjust the Control Center settings. figure 3 Ethernet Cable Ethernet Cable Xbox 360TM PlayStation®3 Cable/DSL Modem 6 english typical setup steps 1) Connect the Power Adapter to the DC 9V IN located on the rear panel of the Control Center 245C. 2) Connect the desired output of the Control Center 245C to your television, using the Component Video, S-Video or RCA Phono Cables supplied. Note: If you are using Component or S-Video Cables as the video output, you will need to connect the RCA Phono (White and red) or Digital Optical Cable to the TV / Hi-Fi to receive audio. Component and S-Video connectors do not carry an audio signal. 3) Connect your AV devices to inputs 1 to 7 ensuring the power is switched off on all devices before connecting. 4) Switch on your TV and select the "External" input channel. (Refer to your television user guide for more details). 5) Switch on the Control Center 245C either by pressing the Power / Standby Button on the front or by using the Remote Control. The Power / Standby LED will illuminate green when the unit is on. 6) The first Input Indicator to illuminate will be Input 1. Select other Inputs by pressing the SELECT Button located on the front of the Control Center 245C or by using the Remote Control. programming the input channel display For easy identification equipment connected to the Control Center 245C it is possible to name each of the 7 inputs on the Input Channel Display. For example should you wish Input 1 to read 'DVD' and Input 2 to read 'GAME', follow this setup procedure: 1) Using the Select Button on the front panel, select the desired Input Channel (1-7) that you would like to name. 2) Open the access cover on the front of the Control Center 245C. 3) Press the SET Button to begin to change the name. The first character on the Input Channel Display will begin to flash. 4) Use the + and - buttons to cycle through all the available characters. When the desired character is displayed, press the SET Button to select the character and move to the next. Repeat the process until you have achieved your desired name. 5) Once you have selected the 5th character the name will be stored and assigned to your chosen Input Channel. Repeat the above procedure for each Input Channel you wish to name. english 7 troubleshooting The Control Center 245C fails to turn on: · Ensure that the Power Adapter is connected correctly and that the power is switched on. [. . . ] Even people who have no history of seizures or epilepsy may have an undiagnosed condition that can cause these "photosensitive epileptic seizures" while watching video games. These seizures may have a variety of symptoms, including lightheadedness, altered vision, eye or face twitching, jerking or shaking of arms or legs, disorientation, confusion, or momentary loss of awareness. Seizures may also cause loss of consciousness or convulsions that can lead to injury from falling down or striking nearby objects. Immediately stop playing and consult a doctor if you experience any of these symptoms. [. . . ]