User manual JUNO JDA 5330 INSTALLATION

[. . . ] We suggest to use Ø 120 mm exhausting pipe. The air is purified by means of a carbon filter and then returned to the room. The active carbon filter can be ordered from the supplier. [. . . ] The manufacturers are not liable for any problems caused by the users failure to observe the above instructions. The hood model JDA 5330 is fitted with two motors. The speed of the motors is adjusted by means of a 4-SPEED switch. Use the high speed switch only in case of high concentration of vapour. The hood should be switched ON several minutes before you start cooking and should be allowed to run until all the vapours have been eliminated. Apply the scheme supplied (Nº 49A) on the right of the cabinet so that the lines marked by the arrows match the cabinet ensuring that they meet at the back and under. Mahe 2 holes, following the sign on the scheme(fig. Fix the hood to the cabinet using screws E (4, 5x16) supplied with the appliance (fig. Use the shim F supplied with the hood for 16 mm cupboard side panels. Fit the shim F to the left and to the right of the fixing curves of the hood and hook them in the holes. The hood may be mounted in cabinets with different depths. The back of the drawer can be adjusted so that the front of the removable drawer is the same depth as the cabinet. Proceed as follows: unscrew the screws G, move the square plates H as required and tighten the screw G (fig. The switching plate is fitted with two switches one for continuous adjustment of the ventilator (left switch) and one for illuminating the work surface (right switch). [. . . ] This filter eliminates the odours and vapours which form during cooking. When used in normal conditions it should be replaced at intervals of 6-8 months. These filter can be ordered from the supplier The carbon filter cannot be washed or regenerated. [. . . ]