User manual JUNO JDK713OE

[. . . ] We suggest to use Ø 150 mm exhausting pipe. -- No food must be cooked flambé underneath the hood. The use of an unprotected flame is dangerous for the filters and could cause fires. Therefore, never use an open flame under the hood. [. . . ] above gas or mixed-fuel burners. Warning! -- The hood cannot be connected to flues of other appliances that run on energy sources other than electricity. -- When the hood is used at the same time of other appliances that run on energy sources other than electricity, provision must be made for an adequate supply of air. Mounting the hood - Fig. Put the template onto the wall and drill two Ø12mm holes. Hang the hood on the hooks and adjust the position of the hood using the two screws on the bottom of the hooks (4). Remove the metal filters (3) and from the inside of the hood mark two point (2). Remove the hood and drill two Ø8mm holes on the marked points. Fit two Ø8mm wall dowels, Hang again the hood and fix the hood definitively with two screws 5X45 (5) from the inside of thehood. Operation The hoods JDK 7130, JDK 8130, JDK 7240 are JDK 8240 are provided with a motor with three speed. For the best performance, we recommend using the low speeds in normal conditions and the high speeds in particular cases of strong odour and vapour concentration. We recommend starting up the hood a few minutes before cooking and keeping it running until all the odours have been eliminated. Maintenance Before performing any maintenance operation, disconnect the hood from the electricity. Mounting the chimney e. Fix the chimney support (7) with two screws 5 x 45 mm (8) and two wall dowels (6) on the wall close to the ceiling. For exhausting version: Fit the connection ring on the top of the hood with two screws Ø 3, 5 x 6, 5 mm (9S) then fit an axhausting pipe long enough to reach the outside (10S). For recycling version: first insert the fixing nooses of the deflector (K) on the rear slot (9K) then fix definitively the deflector (K) on the top of the hood with two screws Ø 3, 5 x 6, 5 mm on the front holes (9K). Prepare the electric connection (11) (see relative chapter). Fit the chimney (12) and fix it on the chimney support with two screws 3, 0 x 9 mm (13). The lower part of the chimney must be slided down and inserted on the housing on the upper part of the hood (14). Fit the two grids (15) on both sides of the chimney. Metal grease filter The cooker hood is fitted with metal filters. Remove the metal filter using the handles designed for this purpose by pulling them backwards and then downwards (Fig. The metal grease filter lasts forever and must be washed either by hand or in the dishwasher (65°C) with suitable detergents. [. . . ] e) Before calling for repair service because the hood fails to light up, make sure the bulbs are screwed in tightly. Before calling for Repair Service because the hood fails to light up, make sure the lamp is well-inserted. Cleaning To clean the outside of the hood use a cloth moistened with denatured alcohol or neutral liquid detergents. Never use products containing abrasive. Attention Failure to observe the rules for cleaning the appliance and changing and cleaning the filters may cause fires. [. . . ]