User manual JUNO JGU2423

[. . . ] Care must be taken to ensure that the appliance does not stand on the electrical supply cable. The domestic refrigerators and freezers are designed to be used specifically for the storage of edible foodstuffs only. Frozen food must not be re-frozen once it has been thawed out. Manufacturers' storage recommendations should be strictly adhered to. [. . . ] The appliance shall not be discarded together with the urban refuse and rubbish. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. Information on your local disposal sites may be obtained from your municipal authorities. Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. For freezers only (except built-in models): an ideal location is the cellar or basement. 12 INSTALLATION If this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Do not use detergents or abrasive powders, as these will damage the finish. Location Fig. 1 Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). Finally, check the alignment of the door and make sure it closes properly. After having reversed the opening direction of the door, discard the original plastic insert removed and fit the insert supplied with the appliance on the opposite side. Secure the bracket with the screws supplied. Take care not to damage the front face of the panel whilst working. Fig. 7 B Insert the adjusting pins (B-Fig. 7) into their locations in the door and screw them in. Fitting a decorative door panel Important: The components needed to fit the decorative panel have been pre-fitted on the appliance. The brackets are secured to the panel by means of the 7 Ø 3. 5x13 screws supplied. Before starting to fit the panel, remove the large top bracket by unscrewing the screws and adjusting pins pre-fitted on the appliance door. The small bottom bracket need not be removed. Fig. 8 1 B C A = = D467 Place the appliance in the position where it is to be built in (Fig. The appliance is fitted with adjustable feet; screw the front and rear feet in or out to adjust the height of the appliance to that of the recess. Hook the decorative panel onto the top part of the door, inserting the pins (B) (on the door) into the elongated holes (1) (in the top bracket fitted to the panel) (Fig. 8). D533 2 Insert the securing screws (C) through elongated holes (2) and fix the panel without tightening the screws (Fig. [. . . ] Fill these trays with water, then put them in the freezer compartment. Do not use metallic instruments to remove the trays from the freezer. 17 Defrosting In the freezer, frost should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds 4 mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. Never use sharp metal tools to scrape off frost as you could damage the appliance. [. . . ]