User manual JUNO JKG2453

[. . . ] JKG 2453 GEBRAUCHSANWEISUNG OPERATING INSTRUCTIONS MODE D'EMPLOI GEBRUIKSAANWIJZING 2222 144-21/1 CONTENTS Warnings . . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page . page 12 13 13 13 13 14 14 16 16 16 16 16 16 17 17 18 19 19 19 19 Installation . . Starting-up and Temperature Regulation . . Ice-cube production . Storage of foods in refrigerator compartment. [. . . ] Remove the middle hinge and refit it on the opposite side. Refit the door and pin (A) on the left side. Remove pin (D) from the right side. Housing's dimensions Height Depth Width 1225 mm 550 mm 560 mm Instructions for total built-in 50-min. 2 For appropriate venting, follow indications in Fig. 7 A Push appliance into housing until stop strip (A) touches the kitchen unit. Apply covers (B) on joint cover lugs and into hinge holes. B D015 D353 Fig. 8 A D265 If after having carried out the operation described in the previous section there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 5 Position the runners (H) at the top and H bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the posi20m tion of the external m holes. After preparing the h o l e s , s c re w t h e D094 runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 9 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. Fasten the appliance D with 4 screws provided in the kit included with the apC pliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 6 8mm Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 10 PR34 Press in the joint covers between the appliance and the kitchen furniture. Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit PR35 door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. 15 OPERATION Starting-up and Temperature Regulation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, to be found on the upper right side of the inner liner clockwise, beyond the «O» position, to start the appliance. Temperature adjustment is obtained by turning the thermostat knob to the required setting. A medium setting is generally the most suitable. [. . . ] 13 The freezer compartment, however, will become progressively covered with frost. This should be removed with the special plastic scraper provided, whenever the thickness of the frost exceeds mm. During this operation it is not necessary to switch off the power supply or to remove the foodstuffs. However, when the ice becomes very thick on the inner liner, complete defrosting should be carried out and it is advisable to carry out this operation when the appliance is empty. [. . . ]