User manual JUNO JKI4038

[. . . ] JKI 2038 JKI 4038 JKI 4068 GEBRAUCHSANWEISUNG OPERATING INSTRUCTION D 2222745-96 Safety Instructions Please read these operating instructions carefully before installing the appliance. These warnings are provided in the interests of your safety. Ensure you fully understand them before installing or using the appliance. If you are unsure about the meaning of these warnings contact the Customer Care Department. [. . . ] Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Maintenance Unplug the appliance before carrying out any maintenance operation. Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorised technicians. Freezer compartment ¥ Remove the frost with a plastic scraper. ¥ Whenever the thickness of the frost exceeds 5 mm complete defrosting should be carried out. Prooceed as follows: ¥ Remove any stored food, wrap it in several layers of newspaper and put it in a cool place. ¥ Pull out the plug from the wall socket or turn the thermostat knob to the ÇOÈ setting. ¥ Leave the door open, place a basin on the top shelf of the refrigerator compartment, under the drain hole, remove the plug as shown in the figure. Defrosting Refrigerator compartment ¥ Defrosting the refrigerator compartment is automatic. The defrost water drains out through a trough into a container at the back of the appliance, above the motor compressor, where it evaporates. ¥ It is important to periodically clean the defrost water drain hole. PR151 D037 ¥ When defrosting is completed, dry the interior thoroughly and refit the plug. ¥ Turn the thermostat knob back to the required setting or replace the plug in the power socket. ¥ Reload the previously removed food into the compartment. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. 14 Cleaning Never use metal objects for cleaning your appliance as it may get damaged. NEVER use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as these will damage the surface and leave a strong odour. Clean the inside with warm water and bicarbonate of soda. To guarantee a safe operation of the fridge, once a year remove the ventilation grille at the base and clean the air channels with a vacuum cleaner. When the appliance is not in use Disconnect the appliance from the electricity supply. Empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. Changing the light bulb ¥ Should the interior light fail to work, first switch off the appliance and disconnect from the electricity supply, then replace the bulb as follows: 1. unscrew the light cover securing screws. unhook the moving part by pressing it as shown in the figure. Replace the bulb by other with another with the same charcteristics. D411 Something not Working Problems may be due to causes which can easily be solved before calling the Technical Service. Please follow these instructions: SYMPTOM Door does not close SOLUTION Weight surpasses the storage limit of the door shelf so spread weight more evenly or take some products out. [. . . ] - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. Door reversal The applianceÕs door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. If the ambient temperature is cold (i. e. [. . . ]