User manual JUNO JKI4361

[. . . ] This appliance is designed to be operated by adults. Children should not be allowed to tamper with the controls or play with the appliance. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. [. . . ] According to the door opening direction, remove relevant pins at the top and at the bottom. 50 mm Positioning The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. ; best performance is obtained with ambient temperature between +16°C and +32°C (class N) or between +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. min. cm 200 2 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. D022 For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. D567 Fig. 2 A Push appliance into housing until stop strip (A) touches the kitchen unit. Fig. 3 A This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. D265 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. If after having carried out the operation described in section 2 there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). 11 Fig. 8 Open the door and push the appliance against the side of kitchen furniture opposite to that of appliance hinges. D Fasten the appliance with 4 screws provided in the kit inC cluded with the apD130 pliance. Snap vent grill (C) and hinge cover (D) into position. Fig. 5 8mm PR34 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 Press in the joint covers between the appliance and the kitchen furniture. D132 Fig. [. . . ] Warning This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. Interior light The light bulb inside the refrigerator compartment can be reached as follows: unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. If the door is open and the light does not come on, check that the bulb is properly screwed in; if it still does not work, replace the bulb with one of the same power. The maximum rating is shown on the light cover. Fig. 14 Periodic cleaning Never use metal objects for cleaning your appliance as it may get damaged. [. . . ]