User manual JUNO JSV5520

[. . . ] Favorit 45250Vi Dishwasher Posudomoe^naq ma[ina Instruction booklet Rukowodstwo po \kspluatacii Dear customer, please read these user instructions carefully. Please observe the safety instructons on the first few pages of this instruction book. Save these instructions and make sure they remain with the dishwasher if it is moved or sold, so that everyone using it through its life can be properly informed on appliance use and safety. The warning triangle and/or specific words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. [. . . ] Open the door and press the On/Off button. When you want the programme to continue again, press the On/Off button once more and close the door. The programme should not be paused for any longer than necessary, because the water inside the dishwasher has cooled down and must be heated again which increases the power consumption. 17 Instruction book Cancelling the drying phase In case you do not want to wait until the drying phase is completed, you can cancel it by open the door. The drying phase is now cancelled. Setting the delay start The programme start can be delayed by 3, 6 or 9 hours. Press the delay start button repeatedly, until the lamp next to the required hours of delay is lit. Press the button for the required programme. After the set delayed start time has elapsed, the programme starts. Reset the delayed start: If the programme has not started, you can change the set time with the delay start button. Cancelling the delayed start: If the programme has not started, the delayed start can be cancelled. Press the delay start button repeatedly, until none of the lamps next to the hours are lit. The required programme starts immediately. Switching the buzzer off Before switching the buzzer off must all programmes have completed. Press the combination buttons simultaneously and hold them pressed in. When the first three programme indicator lamps starts to flash, you can let go of the buttons. The lamp for the buzzer button starts to flash and the lamp for the ended programme cycle is lit. Press the button once more and the lamp for the ended programme cycle goes out. Press out the On/Off button to complete the setting. To reset the function, follow steps 1 and 2 above and then press the buzzer button twice, until the lamp for the ended programme cycle is lit again. 18 Instruction book Switching the dishwasher off / unloading Switch the dishwasher off when the buzzer for ended programme sounds (approx. 15 seconds) or the lamp for the ended programme cycle is lit. Open the door and press the On/Off button. Leave the dishes in the dishwasher for approx. 15 minutes after the end of the programme so that they dry better and cool down. Check the filters to see if they need to be cleaned when the dishwasher has finished the programme. [. . . ] Put the dishwasher into the cupboard and screw the mount plate into position from underneath with 2 screws, with the washers between. Put the spacers provided at the sides of the machine and screw the machine into place in the cupboard. Check that there is a space between the cupboard frame and the wooden door when it is shut. 32 Position- and connection instructions Water inlet The dishwasher is equipped with safety features which are to prevent the water from going back to the fresh water system. These features are according to current water technical safety regulations. [. . . ]