User manual JUNO KGEI5046

[. . . ] ⷠDo not use other electrical appliances (such as ice cream makers) inside of refrigerating appliances, unless they are approved for this purpose by the manufacturer. The refrigerant isobutane (R600a) is contained within the refrigerant circuit of the appliance, a natural gas with a high level of environmental compatibility, which is nevertheless flammable. During transportation and installation of the appliance, be certain that none of the components of the refrigerant circuit become damaged. If the refrigerant circuit should become damaged: ­ avoid open flames and sources of ignition ­ thoroughly ventilate the room in which the appliance is situated It is dangerous to alter the specifications or modify this product in any way. [. . . ] Wherever possible the back of the product should be against a wall to avoid touching or catching warm parts (compressor, condenser) to prevent possible burn. ⷠThe appliance must not be located close to radiators or cookers. ⷠMake sure that the mains plug is accessible after the installation of the appliance. Any electrical work required to do the servicing of the appliance should be carried out by a qualified electrician or competent person. ⷠThis product must be serviced by an authorized Service Centre, and only genuine spare parts must be used. Environment Protection This appliance does not contain gasses which could damage the ozone layer, in The appliance shall not be discarded together with the urban refuse and rubbish. The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. 1 Temperature regulator Switching on Insert the plug into the wall socket. turn the Temperature regulator clockwise to a medium setting. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Unplug the appliance before carrying out any maintenance operation. This appliance contains hydrocarbons in its cooling unit; maintenance and recharging must therefore only be carried out by authorized technicians. periodic cleaning The equipment has to be cleaned regularly: · Clean the inside and accessories with lukewarm water and some neutral soap. ⷠRegularly check the door seals and wipe clean to ensure they are clean and free from debris. Do not pull, move or damage any pipes and/or cables inside the cabinet. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. Take care of not to damage the cooling system. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. [. . . ] The technical information are situated in the rating plate on the internal left side of the appliance and in the energy label. Read the "Safety Information" carefully for your safety and correct operation of the appliance before installing the appliance. Positioning Install this appliance at a location where the ambient temperature corresponds to the climate class indicated on the rating plate of the appliance: Removing the shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. Raise the shelf from the rear and push it forward until it is freed (B). [. . . ]