User manual JURA D6

[. . . ] D6/D60 Instructions for Use Table of contents Your D6/D60 Control elements 4 Important information 6 Proper use . 6 1 Preparing and using for the first time 10 JURA on the Internet . 16 Permanently setting the amount of water for the cup size . 35 9 Technical data 36 10 Index 37 11 JURA contact details / Legal information 40 Scope of validity These instructions for use apply to the following models: D6 D60 U U In the interests of clarity, however, the instructions for use only refer to the ‘D6’ model. [. . . ] E If milk has been prepared, you will be prompted to clean the milk system (CLEAN MILK?You can start milk system cleaning by pressing the Rotary Switch. After 10 seconds the switch-off process continues automatically. 20 3 Daily operation If milk has been prepared but you have not started milk system cleaning, you will be prompted to carry out milk system rinsing first (M-RINSE). CLOSE SWITCH T  Turn the switch to the ° position. You can navigate through the programme items and permanently save the required settings simply by turning and pressing the Rotary Switch. You can make the following settings with the Rotary Switch: Programme item Sub-item Explanation T Select the desired maintenance programme. RINSE M-RINSE, M-CLEAN, RINSE, CLEAN, DESCALE 1 °dH – 30 °dH BUTTONS HARDNESS OFF FROM UNITS LANGUAGE EXIT T Select your settings for speciality coffees. T You can set the water hardness of the water used. , T Set the time after which the D6 should switch off 1 HRS. ML, OZ T Select the unit for the amount of water. E You can exit programming mode directly at any time. Simply touch the P symbol for approximately 2 seconds. Product settings Product Cappuccino In the programme item BUTTONS you can make individual, permanent settings for all products: Coffee strength Temperature Espresso Coffee Amount Water: 25 ML – 240 ML Milk foam: 3 SEC. €“ – Water: 25 ML – 450 ML When you prepare two speciality coffees at once, the temperature and amount of water selected for the single product are used for each cup. Permanent settings in programming mode always follow the same model. Example: Proceed as follows to change the coffee strength for one coffee from NORMAL to STRONG. T  Touch the P symbol for approximately 2 seconds until RINSE appears on the display. T  Turn the Rotary Switch until BUTTONS is displayed. T  Press the Rotary Switch to enter the programme item. ESPRESSO T  Turn the Rotary Switch until COFFEE is displayed. t  Press the Rotary Switch. [. . . ] The coffee is ground too finely and obstructs the system. The water hardness may not have been correctly set. There are foreign objects in the grinder. fILL TANK is displayed although the water tank is full. [. . . ]