User manual JVC IF-C151HDGA

[. . . ] only) CAUTION: Changes or modifications not approved by JVC could void the user's authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. [. . . ] Output channels can be switched by using the monitor or an RS-485 control. Accessaries Make sure that the following items are contained: · Input unit (x 1) · Wire connector (x 1) · Cover (x 1) · Screw (x 8) 1 ENGLISH Installation 7 Preparation · Wear gloves to protect your hands from metal parts on the unit. · You will need a 6 mm Phillips screwdriver. · Turn off the Monitor's main power and unplug the power cable from the AC outlet. 7 Cautions · · · · · Do not touch the wires or board pattern inside of the unit to keep them from being damaged. Do not put any object into the unit from the holes on the unit. Do not force to tighten the screws when attaching the unit to the monitor. Keep the connector cover attached to the monitor's connector if the unit is not attached to the monitor. Do not touch the connector on the right side of the unit. This connector is used only for servicing. 1. Attach the wire connector to the connector on the input unit. Attach the wire connector fully to the input unit's connector. 2. Take out the screws and remove the connector cover from the monitor. · Do not take out other screws than the ones used for the connector cover. · Keep the connector cover and the screws after removing. 3. Attach the input unit to the monitor as illustrated. Secure the input unit using the supplied screws (x 2). 2 4. Attach the wire connector to the connector on the monitor. Attach the wire connector fully to the monitor's connector. 5. Attach the cover to the monitor as illustrated. Secure the cover using the supplied screws (x 6). Make sure to prevent the wire from being caught in between the cover and the monitor. 3 ENGLISH Controls and Features 1 2 3 1 Audio output terminals (2 lines) Decodes EMBEDDED AUDIO signals and outputs them as analogue signals. \ See the table below for the combinations of the audio channels output from the CH1 or CH2 terminal. Audio output modes 1ch 2ch 3ch 4ch 5ch 6ch 7ch 8ch 1­2ch 3­4ch 5­6ch 7­8ch 1­4ch 5­8ch AUTO* Audio output terminals CH1 CH2 channel 1 channel 2 channel 2 channel 2 channel 3 channel 4 channel 4 channel 4 channel 5 channel 6 channel 6 channel 6 channel 7 channel 8 channel 8 channel 8 channels 1+2 channels 1+2 channels 3+4 channels 3+4 channels 5+6 channels 5+6 channels 7+8 channels 7+8 channels 1­4 channels 1­4 channels 5­8 channels 5­8 channels 1­8 channels 1­8 * The AUTO setting mixes and outputs all 8 signal channels. [. . . ] You can turn on/off the AUDIO LEVEL METER display or change its settings using the menu on the monitor. For more details, refer to the monitor's manual. NOTE: The type of signal coming through the IN C and IN D terminals are automatically recognized--HD SDI or SD SDI signal. Note, however, that input lines are not changed automatically. 5 ENGLISH Specifications IF-C151HDG Multi-Format SDI Unit Consult your dealer. [. . . ]