User manual JVC KD-DV6202

[. . . ] ­ it may obstruct the operation of safety devices such as air bags. If you need to operate the unit while driving, be sure to look ahead carefully. The driver must not watch the monitor while driving. [. . . ] Through DIGITAL OUT (optical): Digital signals (Linear PCM, Dolby Digital*1, DTS*2, MPEG Audio) are emitted through this terminal. (For more details , see page 38 of the INSTRUCTIONS. ) To reproduce multi-channel sounds such as Dolby Digital and DTS, connect an amplifier or a decoder compatible with these multi-channel sources to this terminal, and set "DIGITAL AUDIO OUTPUT" correctly. * Is the rear ground terminal connected to the car's chassis using shorter and thicker cords?The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC IN-CAR ENTERTAINMENT dealer or a company supplying kits. If you are not sure how to install this unit correctly, have it installed by a qualified technician. *3 When you stand the unit, When using the optional stay / Beim Verwenden der Anker-Option / Lors de l'utilisation du hauban en option / Wanneer u de steun gebruikt (facultatief) When installing the unit without using the sleeve / Beim Einbau des Geräts ohne Halterung / Lors de l'installation de l'appareil scans utiliser de manchon / Wanneer u het apparaat zonder huis installeert In a Toyota car for example, first remove the car radio and install the unit in its place. Install the unit at an angle of less than 30°. : When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws are used, they could damage the unit. Before removing the unit, release the rear section. Insert the two handles, then pull them as illustrated so that the unit can be removed. For some VW/Audi or Opel (Vauxhall) automobile / Bei bestimmten VW-/Audi- order Opel(Vauxhall-) Fahrzeugen / Pour certaine voiture VW/Audi ou Opel (Vauxhall) / Voor bepaalde VW/Audi en Opel (Vauxhall) auto's You may need to modify the wiring of the supplied power cord as illustrated. Contact your authorized car dealer before installing this unit. If your car is equipped with the ISO connector / Wenn Ihr Fahrzeug mit dem ISO-Steckverbinder ausgestattet ist / Si votre voiture est équippée d'un connecteur ISO / Indien uw auto een ISO-aansluiting heeft From the car body Von der Fahrzeugkarosserie De la carrosserie de la voiture Van het chassis van de auto Use modified wiring 2 if the unit does not turn on. View from the lead side Von der Kabelseite aus gesehen Vue à partir du côté des fils Gezien vanaf de spanningstoevoerkant The leads of the power cord and those of the connector from the car body may be different in color. 2 Connect the colored leads of the power cord in the order specified in the illustration below. [. . . ] Connect the remote lead (blue with white stripe) to the remote lead of the other equipment so that it can be controlled through this unit. Disconnect the speakers from this unit, connect them to the amplifier. Leave the speaker leads of this unit unused. [. . . ]