User manual JVC THC3J-TH-C3 Instruction Manual

[. . . ] DVD DIGITAL THEATER SYSTEM TH-C7 Consists of XV-THC7, SP-PWC7, SP-THC7F, SP-THC7C and SP-THC5S TH-C6 Consists of XV-THC6, SP-PWC6, SP-THC6F, SP-THC6C and SP-THC6S TH-C5 Consists of XV-THC5, SP-PWC5, SP-THC5F, SP-THC5C and SP-THC5S TH-C4/TH-C3 Consists of XV-THC4, SP-PWC4, SP-THC4F, SP-THC4C and SP-THC4S Consists of XV-THC3, SP-PWC3, SP-THC3F, SP-THC3C and SP-THC3S INSTRUCTIONS For Customer Use: Enter below the Model No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. GVT0150-001C [J/C] Warnings, Cautions and Others/Mises en garde, précautions et indications diverses Note to CATV system installer: This reminder is provided to call the CATV system installer's attention to Section 820-40 of the NEC which provides guidelines for proper grounding and, in particular, specifies that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as practical. For Canada CAUTION: TO PREVENT ELECTRIC SHOCK, Pour le Canada ATTENTION: POUR EVITER LES CHOCS MATCH WIDE BLADE OF PLUG TO WIDE SLOT, FULLY INSERT. ELECTRIQUES, INTRODUIRE LA LAME LA PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE LA PRISE ET POUSSER JUSQUAU FOND. For Canada THIS DIGITAL APPARATUS DOES NOT EXCEED THE CLASS B LIMITS FOR RADIO NOISE EMISSIONS FROM DIGITAL APPARATUS AS SET OUT IN THE INTERFERENCE-CAUSING EQUIPMENT STANDARD ENTITLED "DIGITAL APPARATUS, " ICES-003 OF THE DEPARTMENT OF COMMUNICATIONS. Pour le Canada CET APPAREIL NUMERIQUE RESPECTE LES LIMITES DE BRUITS RADIOELECTRIQUES APPLICABLES AUX APPAREILS NUMIRIQUES DE CLASSE B PRESCRITES DANS LA NORME SUR LE MATERIEL BROUILLEUR: "APPAREILS NUMERIQUES", NMB-003 EDICTEE PAR LE MINISTRE DES COMMUNICATIONS. CAUTION! To avoid personal injury or accidentally dropping the unit, have two persons unpack, carry, and install the unit. ATTENTION! Pour éviter toute blessure personnelle ou toute chute accidentelle de l'appareil, celui-ci doit être déballé, transporté et installé par deux personnes. SP-THC7: 45 kg/100 lbs TH-C6: 38 kg/84 lbs TH-C5: 39 kg/86 lbs TH-C4: 26 kg/58 lbs TH-C3: 26 kg/58 lbs SP-THC7: 45 kg/100 lbs TH-C6: 38 kg/84 lbs TH-C5: 39 kg/86 lbs TH-C4: 26 kg/58 lbs TH-C3: 26 kg/58 lbs G-1 Warnings, Cautions and Others/Mises en garde, précautions et indications diverses IMPORTANT FOR LASER PRODUCTS 1. [. . . ] You can select these modes by pressing SURROUND. 25) Linear/Packed PCM (Multichannel) -- -- -- -- -- 24 Advanced operations 7 All Channel Stereo (DSP) All Channel Stereo (ALL ST) mode can reproduce a larger stereo sound field using all the connected (and activated) speakers. All Channel Stereo can be used while reproducing 2 channel stereo source. Normal stereo sound All Channel Stereo See page 24 for button locations. 7 When playing back digital multichannel software (except during SURR OFF mode) The appropriate multichannel surround mode (Dolby D, DTS Digital Surround or Linear/Packed PCM) is automatically selected. 7 When playing back 2 channel source You can select either mode of Dolby Pro Logic II (MOVIE/ MUSIC) or the DSP (ALL ST) mode. Press SURROUND repeatedly to select the desired mode. 7 Indicators on the display window Digital signal format indicators PPCM, SURR: Lights when DVD AUDIO packed PCM signals comes in. LPCM, SURR: Lights when Linear PCM signal comes in. GD, SURR: Lights when Dolby D signals come in. C, SURR: Lights when DTS Digital (Surround) signals come in. No indication: No digital signal indicator lights when analog signals come in. Dolby Surround/DSP mode indicators GPLII, SURR: Lights when Dolby Pro Logic II mode is activated. SURR: Lights when All Channel Stereo mode is activated. a: Lights when the left channel signal comes in. b: Lights when the center channel signal comes in. c: Lights when the right channel signal comes in. d: Lights when the LFE channel signal comes in. g: Lights when the surround left channel signal comes in. i: Lights when the surround right channel signal comes in. h: Lights when the monaural surround channel signal or 2 channel Dolby Surround signal comes in. The channel with " " shows that the corresponding speakers are reproducing the channels' sound. If the channels' sound decoded into 5. 1 channel is reproduced, only " " lights. The surround mode is turned on and the current surround mode appears on the display window. Each time you press the button, the surround mode changes. To turn off the surround mode Press SURROUND repeatedly until SURR OFF appears on the display window. Storing adjustments -- auto memory When you turn the power off, the system memorizes the current surround mode. The memorized mode is automatically recalled when you turn the power on. [. . . ] The decode mode is not set correctly. Connect the power cord and system cord correctly. 6) Hide the remote sensor from direct sunlight. 3) Change the scan mode to "INT-LACE". 18) No picture is displayed on the TV screen. [. . . ]