User manual JVC TK-C215V4

[. . . ] DOME CAMERA TK-C215V4 TK-C215V12 INSTRUCTIONS (A) *TK-C215V4 is used in the above illustration. For Customer Use: Enter below the Serial No. Retain this information for future reference. TK-C215V4/TK-C215V12 LST0420-001B Introduction Safety Precautions Information for Users on Disposal of Old Equipment [European Union] This symbol indicates that the electrical and electronic equipment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for the recycling of electrical and electronic equipment for proper treatment, recovery and recycling in accordance with your national legislation. [. . . ] INT MANUAL ON ON STATE SPOT A [IRIS LEVEL] Iris level adjustment For adjusting the level of the automatic aperture control lens. This adjustment only needs to be made when required. Use this to accommodate particular shooting conditions. To darken image: Counterclockwise (L side) To brighten image: Clockwise (H side) NOTE: Prior to adjusting the aperture level, ensure to set the 1 [AGC] Switch of the function selection switch G to AOFFB. Otherwise, when the level is turned too far toward L, the AGC function activates increasing sensitivity and the picture may look uneven. 12 POSITION SELECT 1 2 3 4 5 6 7 8 4 2 A B C D LEVEL [MEMORY] WHT. BAL. ZOOM/FOCUS LL PHASE RESET/[SPOT] E F G adjustment switches/position memory button Use the [JTELE] and [KWIDE] switches to zoom, and the [HFAR] and [INEAR] switches to adjust focus. 25) Press the [MEMORY] button to register the position. 25) C [ALARM POSITION] status indication lamp Light off : Registration of home position is enabled Light on (red) : Lens initializing. Light on (green): Registration of alarm position is enabled Blinking (green) : Position memory registration mode N memory registration completed (A pg. 25) D [POSITION SELECT] POSITION SELECT button Press this button to switch between the home and alarm positions. Display on the status indication lamp C will change accordingly. 25) E [RESET/SPOT] RESET/SPOT button When this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value. When the 2 [SELECT] switch is set to [WHT. BAL. ], the white balance is reset to the default value. When the switch is set to PHASE, the phase is reset to the default value. When setting to SPOT: When this button is pressed, white-spots are corrected. For instructions on correcting white-spots, see AWhite-spot correctionB (A pg. F [R/B, +/-] R/B, +/- adjustment button This button is pressed when manually adjusting the white balance or when adjusting the vertical phase of the line lock. The function of this button is selected using the 2 [SELECT] switch. When manually adjusting the white balance: Press the R button to increase the red tint and decrease the blue tint. Press the B button to increase the blue tint and decrease the red tint. When adjusting the phase: Press the + or - button to adjust the phase. Setting this switch to AONB automatically increases the sensitivity even when the brightness of the subject is insufficient. (Default setting: ON) H IRIS FAR WIDE TELE NEAR L R B 2. [. . . ] Mount the dome cover. *TK-C215V4 is used in the above illustration. Align the position marks on the camera unit and dome cover, followed by pressing in directly to mount the cover. 1. Mount the inner dome . Mount the inner dome to the claws (3 locations). CAUTION: Press the dome over until a "click" sound is heard. Failure to mount the cover firmly may cause this cover to fall off. CAUTION: Mount the inner dome such that it does not cover the lens. When mounting the inner dome, be careful not to move the lens position. [. . . ]