User manual JVC TM-A140E

[. . . ] COLOUR VIDEO MONITOR BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS ISTRUZIONI MANUAL DE INSTRUCCIONES : FARB-VIDEO-MONITOR : MONITEUR VIDÉO COULEUR : MONITOR VIDEO A COLORI : MONITOR DE VIDEO A COLOR ENGLISH ESPAÑOL ITALIANO ­ + B A ON OFF PHASE TM-A140E TM-A140E INSTRUCTIONS CHROMA BRIGHT CONTRAST MENU VOLUME/SELECT INPUT SELECT POWER LCT2142-001A-H FRANÇAIS DEUTSCH Thank you for purchasing this JVC colour video monitor. Before using it, read and follow all instructions carefully to take full advantage of the monitor's capabilities. SAFETY PRECAUTIONS In order to prevent any fatal accidents caused by misoperation or mishandling the monitor, be fully aware of all the following precautions. WARNINGS To prevent fire or shock hazard, do not expose this monitor to rain or moisture. Dangerous high voltages are present inside the unit. Do not remove the back cover of the cabinet. [. . . ] Press the VOLUME/SELECT buttons to adjust the speaker volume. ­ + Press this button to display the speaker volume level on the screen. Setting range Function displayed 5 ­ + Contents Advance the menu item. Lower the adjustment value (to the minimum). Raise the adjustment value (to the maximum). Exits the <MENU> screen. VOLUME/SELECT Menu items SHARPNESS COLOR SYSTEM Purpose Picture sharpness Colour system 00 AUTO +1 +2 NTSC +3 PAL +4 +5 3 2 EXIT * Normally set the COLOR SYSTEM to the AUTO mode. If reception in the AUTO mode is not good, set it to the exclusive mode (NTSC or PAL) corresponding to the received colour system. 4. If you want to set the other menu items, repeat procedures 2 and 3. Press the MENU button to quit. Front panel button MENU Function displayed EXIT Contents Quit (or Release) the <MENU> screen. MENU 7 ENGLISH 3. Press the VOLUME/SELECT buttons to set. the front panel buttons (7 buttons on the left) correspond to the function displayed. HOW TO USE THE MENU FUNCTIONS (cont'd) DISPLAY AND SELECTIONS IN THE <SET-UP MENU> MODE (SETTING) You can set the following set-up menu items. POSITION WHITE BALANCE CONTROL LOCK <SET-UP MENU> screen 1 Note: Parameters for H. POSITION can be set separately depending on the video input (Input A or Input B) selected by the input select buttons on the front panel. Select the required video input with the input select buttons on the front panel in advance. <SET­UP MENU> H. POSITION : 00 WHITE BALANCE CONTROL LOCK : OFF 2 3 EXIT 4 1. While pressing the MENU button, press the ) button. PHASE ( The <SET-UP MENU> screen is displayed. PHASE CHROMA BRIGHT CONTRAST MENU ­ + VOLUME/SELECT <Front panel button> PHASE MENU 1 Selection mark (3): Indicates the menu item you select. 2. Press the PHASE ( ) or CHROMA ( select the desired menu item. Front panel button PHASE CHROMA ) button to 2 Menu item: Menu items you can select. 3 Setting display: Indicates the current settings (value). A selection mark (3) is put next to the selected item. Function displayed ) ) 5 Contents Advance selection mark (3). Reverse selection mark (2). 4 Function display: The functions of the front panel buttons (7 buttons on the left) correspond to the function displayed. Function displayed 5 ­ + 3 Contents Advance the menu item. Lower the adjustment value (to the minimum). Raise the adjustment value (to the maximum). Exit the <SET-UP MENU> screen (release). [. . . ] (See page 6. ) Connect the video signal cable firmly. (See page 11. ) Set the connected component correctly. Adjust the speaker volume with the VOLUME/SELECT buttons. (See page 6. ) Connect the audio signal cable firmly. [. . . ]