User manual JVC TM-H1950CGE

[. . . ] COLOR VIDEO MONITOR ENGLISH ASPECT A B C SLOT D BEDIENUNGSANLEITUNG : FARB-VIDEO-MONITOR MANUEL D'INSTRUCTIONS : MONITEUR VIDÉO COULEUR MANUALE DI ISTRUZIONI : MONITOR VIDEO A COLORI INSTRUCCIONES : MONITOR DE VIDEO A COLOR !"#$%&'(&) TM-H1950CG TM-H1750CG For Customer Use: Enter below the Serial No. which is located on the rear of the cabinet. Retain this information for future reference. Pour l'usage du client: Enter ci-dessous le numéro de série qui est situé sur l'arrière du coffret. [. . . ] * The on-screen display goes off when you press MENU button. Phase control is effective only in the NTSC color system mode. Chroma control is not effective when receiving RGB and B/W or when no signal is input. (Except when a component signal is input. ) When CHROMA is adjusted to "­40, " the picture becomes less colorful. "NO EFFECT" is displayed (for about 3 seconds) when your selected function has no effect. To change the display position on screen, set UPPER or LOWER with ADJ. BAR POSI. 10 VIDEO SIGNAL CONTROLS Use these buttons for video signal control. UNDER SCAN Press the UNDER SCAN button to reduce the size of display area so that the whole picture is displayed on screen. Use to check the picture frame. COLOR OFF To display a black and white picture, press the COLOR OFF button to input the luminance signal only. Use to check noise in the luminance signal or for white balance adjustment. Note: No effect with RGB input. BLUE CHECK Input the standard color-bar signal for your TV system and display it on the screen. When the BLUE CHECK button is pressed, the red and green signals are cut and only the blue signal is displayed. The BLUE CHECK function adjusts and checks CHROMA (COLOR) GAIN and PHASE. LEVEL has been initialized when a component signal is input. [Procedure] 1. Input the standard color-bar signal for your TV system and display it on the screen. Press the CHROMA button to adjust the chroma so that the blue bars on the left and right sides of the screen have the same brightness. (Only when an NTSC signal is input) Press the PHASE button to adjust the phase so that the two blue bars at the center of the screen have the same brightness. (Only when an NTSC signal is input) Repeat procedures 3 and 4 for the adjustment so that all four blue bars on the screen have the same brightness. When you have finished making the adjustment, press the BLUE CHECK button to deactivate. Blue Blue Blue Initializing COMPO. LEVEL (when a component signal is input) with the IF-C01COMG component/RGB input card inserted When a component signal is input, be sure to adjust (initialize) the COLOR offset in COMPO. Input the standard color-bar signal for your TV system and display it on the screen. LEVEL in the <MENU> screen and then adjust it with VOLUME +/­ buttons so that the blue bars on the left and right sides of the screen have the same brightness. Quit the <MENU> screen and press the BLUE CHECK button. Make sure that the blue bars on the left and right sides of the screen have the same brightness. [. . . ] Function buttons on the front panel do not function. The INPUT SELECT buttons do not function. Is the monitor close to a speaker, magnet or any other device generating a strong magnetic field?Is the aspect ratio set to 16:9? Has the UNDER SCAN button been pressed so the UNDER SCAN button lights?(Has the CONTROL LOCK function been set to ON?) Is input selection under external control? [. . . ]