User manual JVC UX-VJ3W

[. . . ] Serial No. GVT0032-008A [B] Warnings, Cautions and Others IMPORTANT for the U. K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. [. . . ] If the CD cannot be read correctly (because it is scratched, for example), "00 0000" appears on the display. You can insert a CD while listening to another source. Inserting a CD 1 Press the CD OPEN/CLOSE 0 button on the Unit (or the CD 0 button on the Remote Control). The CD cover opens. CAUTIONS: DO NOT try to open or close the CD cover by hand as it will be damaged. When you place or take out a CD, do not let it fall. Be careful not to scratch your fingers with the CD cover. 2 Place a CD, with its label side out as shown below. Press down on the portions around the CD's center hole until you hear a click. Unloading a CD Take out the CD as shown below. 12 Basics of Using the CD Player -- Normal Play Playing a CD 1 Insert a CD. 2 Press the CD #/8 button. The first track of the CD begins playing. 4 Press the PROGRAM button. The System enters the programing mode and the PROGRAM indicator lights up. PROGRAM PROGRAM RANDOM 5 Press the > or < button to select the track to program. > button: Increases the track number by 1. < button: Decreases the track number by 1. When the > or < button is held down, the track number changes rapidly. Track number Playback time 6 Press the SET button. The track number that has already played disappears from the music calendar. The CD Player automatically stops when the last track of the CD has finished playing. Program order number SET To stop playing the CD, press the 7 button. The following information for the CD is displayed. Total playback time of the programed tracks Total track number Total playback time 7 Repeat steps 5 and 6 to select the other tracks for the program. You can see the total playback time of programed tracks on the display. To skip a track during playback, press the button (or the >/UP button on the Remote Control) to jump to the next randomly selected track. Press the 4 button (or the </DOWN button on the Remote Control) to jump back to the start of a track being played. To exit from Random Play mode, press the 7 button. Repeating Tracks You can set the program or individual track currently playing to repeat as many times as you like. Press the REPEAT button on the Remote Control. The Repeat indicator changes at each press of the button, as shown below. : In Normal Play mode, repeats all the tracks. In Program Play mode, repeats all the tracks in the program. In Random Play mode, repeats all the tracks in random order. To exit from Repeat mode, press the REPEAT button until the Repeat indicator on the display goes out. s In Random Play s Repeat mode remains in effect even when you change the play mode. ALL Locking the CD cover You can lock the CD cover and prohibit to unload the CD. This operation is possible only using the buttons on the unit. To prohibit unloading the CD, press the button while holding the 7 button. [. . . ] Store CDs in their cases, and keep them in cabinets or on shelves. Keep the system's CD cover closed when not in use. Do not store the tape: - In dusty places - In direct sunlight or heat - In moist areas - On a TV or speaker - Near a magnet Cleaning the Lens If the lens in the CD pickup is dirty, sound degradation may take place. Open the CD cover and clean the lens as shown. Use a blower (available from a camera store) to blow dust off the lens. [. . . ]