User manual JVC XVN652S-XV-N652 Instruction Manual

[. . . ] DVD PLAYER XV-N652S XV-N650B For Customer Use : INSTRUCTIONS Enter below the Model No. which are located on the rear of cabinet. Retain this information for future reference. Serial No. LPT1147-001A CAUTION RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION: The apparatus should not be exposed to water (dripping or splashing) and no objects filled with liquids, such as vases, should be placed on the apparatus. CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. This lightning flash with arrowhead symbol within an equilateral triangle is intended to alert the user to the presence of uninsulated dangerous voltage within the products enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. [. . . ] Use v / V to select the desired setting then press ENTER to confirm your selection. Press SETUP or PLAY (N) to exit the Setup menu. 12 LANGUAGE DISPLAY Menu Language Select a language for the Setup menu and then on-screen display. Disc Audio / Subtitle / Menu Select the language you prefer for the audio track (disc audio), subtitles, and the disc menu. Original ­ Refers to the original language in which the disc was recorded. Other ­ To select another language, press numeric buttons and then ENTER to enter the corresponding 4-digit number according to the language code list on the page 24. If you enter the wrong language code, press CLEAR. Off (for Disc Subtitle) ­ Turn off Subtitle. TV Aspect 4:3 ­ Select when a standard 4:3 TV is connected. 16:9 ­ Select when a 16:9 wide TV is connected. Display Mode The Display Mode setting works only when the TV Aspect mode is set to 4:3. Letterbox ­ Displays a wide picture with bands on the upper and lower portions of the screen. Panscan ­ Automatically displays the wide picture on the entire screen and cuts off the portions that do not fit. 13 Reference Operation Installation and Setup Introduction AUDIO Each DVD disc has a variety of audio output options. Set the players AUDIO options according to the type of audio system you use. DRC (Dynamic Range Control) With the DVD format, you can hear a programs soundtrack in the most accurate and realistic presentation. However, you may wish to compress the dynamic range of the audio output (the difference between the loudest sounds and the quietest ones). This allows you to listen to a movie at a lower volume without losing clarity of sound. Vocal Set to On only when a multi-channel karaoke DVD is playing. The karaoke channels on the disc mix into normal stereo sound. Dolby Digital / DTS / MPEG Bitstream ­ Select "Bitstream" if you connect this units DIGITAL OUT jack to an amplifier or other equipment with a Dolby Digital, DTS or MPEG decoder. PCM (for Dolby Digital / MPEG) ­ Select when connected to a two-channel digital stereo amplifier. DVDs encoded in Dolby Digital, MPEG will be automatically downmixed to two-channel PCM audio. Off (for DTS) ­ If you select "Off", the DTS signal is not output through the DIGITAL OUT jack. (Frequency) If your receiver or amplifier is NOT capable of handling 96 kHz signals, select 48 kHz. When this choice is made, this unit automatically converts any 96 kHz signals to 48 kHz so your system can decode them. If your receiver or amplifier is capable of handling 96 kHz signals, select 96 kHz. [. . . ] Press ENTER on the remote control to change the unit's code. The code currently set on the remote control is displayed on the front display panel for approximately 5 seconds, and is applied to the unit. Note: If you change the batteries of the Remote Control with C1 or C2 code, the remote control code is set to C3 automatically. In this case, you should reset the remote control code described above. 23 Reference 2. [. . . ]