User manual JWIN JL-CD808

[. . . ] If the clock resets to ]12:00^ on the Clock Display, it indicates the battery is dead or not connected properly. BATTERIES PRECAUTIONS Follow these presautions when using batteries in this device: 1. Use only the size and type of batteries specified. Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. [. . . ] Keep the disc compartment closed when not in use to prevent dirt and dust from entering the mechanism. Never place more than one disc into the disc compartment at any time. If the disc is correctly loaded, the total number of tracks on the disc will be displayed: Notes: After the disc compartment is fully closed, the disc information may not appear on the display. This means that the disc is improperly loaded (most likely it is upside down). To check, open the disc compartment again and reload the disc. DISC PLAY m m m m Insert a CD as described in the previous section and close the disc compartment. The display will then show the total number of tracks. Press the PLAY/PAUSE button to start playback. To skip forward or backward through the tracks on the disc, press the SKIP forward / backward buttons. m When the disc is through playing, it will stop. Press STOP button to stop disc before it is finished. Notes: - If the disc is deeply scratched, or too dirty, disc play may not start. If an improperly centred disc is played, noise can be heard in the mechanism. The use of such discs should be avoided. - If the disc is inserted incorrectly, or the disc is damaged the display will show ]No disc^. 4 DISC ERRORS This compact disc player has built-in error compensation circuits to correct for minor defects in a disc. There are limits, however, to the amount of correction available. In some cases, the CD player may skip some tracks, or parts of tracks, on a disc during disc play. This problem may be caused by defects (such as scratches) in the disc being played, which are too large for the error compensation circuits to handle. If you encounter this problem, check the CD player's operation as follows, before having the unit serviced: Play a new disc. If the CD player operates normally, the skipping problem is probably due to a defective disc. TO STOP A CD PART WAY THROUGH Press the STOP button. Disc play will stop and the display will show the total number of tracks To temporarily stop disc play (pause mode), press the Play/Pause button. Disc play will stop at the current play position. To resume disc play, press the PLAY/PAUSE button again. REPEAT DISC PLAY Use the REPEAT button to listen to an entire disc, one track repetitively. [. . . ] Make sure the power is off (STANDBY/ON indicator is NOT lit). Slide the BUZZER/ MUSIC switch to the MUSIC position. When the actual time matches one of the selected preset alarm times, the unit automatically turns on for 60 minutes and then shuts off. Note: TO SHUT m THE - When the disc is through playing it will stop. ALARM OFF To shut the alarm off, press the STANBY/ON button once and the alarm time will be reset for the next day. Slide the desired ALARM 1 or ALARM 2 switch to the OFF position to turn off the alarm and not set it for the next day. [. . . ]