User manual JWIN JT-P850

[. . . ] 14 minutes of voice storage time (1M*4 DRAM) b). Voice date -time stamp (DTS) and user prompts. OGM (up to 50seconds), Memo, ICM recording up to 1 minute. Erase each message/all messages, save all erased messages function. [. . . ] - OGM1 plays immediately after recording stops. - Press ANS/OGM key or PLAY/STOP key will stop playback. 5. 2 OGM2 - Announce-only OGM (OGM2) is an answer-only message. Incoming message cannot be recorded but the remote operation is allowed to perform. When memory full occurs during recording or the total number of saved messages exceed 59, OGM 2 will be announced to remind the user that memory full occurs. 2. 2. 6 Playing all ICM Messages At beginning of playback LCD will show the total number of messages meanwhile DAM announces the same content by voice. Procedure of playing all messages is as follows: 2. 2. 6. 1 Playback - Press the " PLAY/STOP " key once, the messages will be sequentially played in the order first in first out. (Only if no new message is recorded or all new message(s) is/are played, otherwise only the new message(s) will be played. ) - If date-time stamp (DTS) has been set, the total number of messages DTS is first played. Then each message is played with message number DTS played first and clock DTS played last. 6. 2 Skip message - Press " OGM/FORWARD " key to skip the DTS play or message play, and play the next message. PAGE 3 2. 2. 6. 3 Repeat message - Press " MEMO/REPEAT" key to replay the repeat current message or press twice to replay previous message. - When last is completed it announces "End of message". 6. 4 Erase single message - Press " ERASE " key to erase the message currently being played back. 6. 5 Stop message play - Press " PLAY/STOP " key to abort the message play. 7 Playing new ICM Messages Procedure of playing new messages is as follows: - If new message(s) has/have been recorded, the ANSWER ON/ OFF LED will keep flashing. - Press the " PLAY/STOP " key, the new messages will be sequentially played - If DTS has been set, the total number of messages DTS is first played. Then each message is played with message number. DTS played first and clock DTS played last. - The ANSWER ON/ OFF LED will stop flashing but will be turned on after all new messages have been played to indicate the absence of new messages. Recording a Memo Memo is a message left for others who directly access to the answering machine. - Press and hold the " MEMO/repeat " key for about 2 seconds. Release the key after a short beep, LED displays "oo". Memo recording will then start after a long beep. [. . . ] 2. 2. 15 Room Monitor While in remote control mode, the user can monitor the room status by entering the corresponding tone command. In room Monitor State, the user can monitor the status from telephone line. The duration of room Monitor State is set to 15 seconds. 2. 2. 16 ICM Recording When a call is received in answer-record mode, the machine will play OGM1, and then performs ICM recording. [. . . ]