User manual JWIN JX-CD3003D

[. . . ] FCC INFORMATION This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful interference, and (2) this device must accept any interference received. including interferencde that may cause undesired operation. CAUTION: WHEN INSTALLING THE BATTERIES To prevent leakage from the batteries, which is corrosive and can cause personal injury and damage to the unit, observe the following precautions: 1. [. . . ] Servicing - Do not attempt to service this product yourself as opening or removing covers may expose you to dangerous voltage or other hazards. Refer all servicing to qualified service personnel. Damage Requiring Service - Unplug this product from the wall outlet and refer servicing to qualified service personnel under the following conditions: a) when the power-supply cord or plug is damaged, b) If liquid has been spilled, or objets to have fallen into the product, c) If the product has been exposed to rain or water, d) If the product does not operate normally by following the operating instructions. Adjust only those controls that are covered by the operating instructions as an improper adjustment of other controls may result in damage and will often require extensive work by a qualified technician to restore the product its normal operation. e) If the product has been dropped or damaged in any way, and f) when the product exhibits a distinct change in performance-this indicates a need for service. Replacement Parts - When replacement parts are required, be sure the service technician has used replacement parts specified by the manufacturer or have the same characteristic as the original part. Unauthorized substitutions may result in fire, electric shook, or other hazards. Safety Check - Upon completion of any service or repairs to this product, ask the service technician to perform safety checks to determine that the product is in proper operating condition. Heat - The product should be situated away from heat sources such as radiators, heat registers, stoves, or other products (including amplifiers) that produce heat. FIGURE 1 EXAMPLE OF ANTENNA GROUNDING AS PER NATIONAL ELECTRICAL CODE ANTENNA LEAD IN WERE GROUND CLAMP ANTENNA DISCHARGE UNIT (NEC SECTION 810-20) ELECTRONIC SERVICE EQUIPMENT GROUND CLAMPS POWER SERVICE GROUNDING ELECTRODE SYSTEM (NEC ART 250. PART H) GROUNDING CONDUCTORS (NEC SECTION 810-21) 3 78 9 6 3 11 5 1 14 10 4 2 13 12 FM MODE /BEAT CANCEL 20 19 18 17 16 15 22 MONO ST 1 2 21 23 24 25 28 27 26 25 Fig. 1 VOLTAGE 110 120 220 240 110 120 VOLTAGE 220 240 ~ SELECTOR (For dual voltage model only!) ~ ~ SELECTOR ~ Fig. 2 4 Fig. 3c Fig. 4 5 Fig. 5 Fig. 6 Fig. 7 Fig. 8 Fig. 9 6 ENGLISH PRECAUTIONS The apparatus shall not be exposed to dripping or splashing. Wh en th e b a t ter ies hav e bec ome discharged, they must be disposed of in a safe manner which complies with all applicable laws. GENERAL OPERATION CD PLAY Use compact discs bearing the symbol shown in Fig. 5 In addition to conventional 12 cm CDs, this system can be used to play 8 cm CDs without an adapter. Press the CD compartment lid (CD OPEN/ CLOSE portion) to open it. Place the disc with the label facing up on the turntable (Fig. Press the CD compartment lid (CD OPEN/ CLOSE portion) to close it. The total number of tracks on the disc appears on the TRACK NO. - To start play from the desired track, select the track by using the or buttons, then press the button. Note: If a disc is loaded upside down, or if no disc is loaded, 00 appears and the CD player will not operare. When the last track has been played, the player stops automatically. To turn the CD Player off, set the function switch to TAPE/OFF. Note: - Do not open the CD compartment during CD play. [. . . ] Set the BAND switch to FM or AM as desired. Tune in a desired station by turning the TUNING control. To turn the radio off, set the FUNCTION switch to TAPE/OFF. To receive FM stereo broadcasts Set the FM MODE switch to ST. [. . . ]