User manual JWIN JX-CD404

[. . . ] Ventilation · The slots and openings on the appliance are for ventilation. Do not cover or block them as it could lead to overheating. · NEVER let children push anything into the holes or slots on the cases. Servicing · There are no user serviceable parts in your portable stereo. [. . . ] There is a built in ferrite aerial for AM signal. Move or rotate the unit to obtain the best medium wave reception. Using the CD player Handling Compact Discs Error compensation The unit has built in error compensation citcuits which enable it to keep playing despite any minor defects in the disc. However, if the defects are too great, the play may skip some tracks during play. If you encounter this problem play a new disc and if the CD player operates normally, the skipping problem is probably due to a defective disc. To remove a CD from its storage case, press down on the center of the case and lift the disc out. Avoid touching the recorded side of the disc. Loading CDs · Set the Function Selector to CD position. · Place the CD in the compartment with the label side facing upward. When fully closed the CD player starts to spin the disc. The display shows the total number of tracks on the CD. · Only remove the CD when it has stopped spinning. Please note Do not put anything other than a CD in the compartment. Keep the lid closed when not in use to prevent dirt and dust from getting into the mechanism. Never insert more than one CD at a time. If a disc is deeply scratched or too dirty, it may not play. Playing CDs Once you have loaded a CD, press the CD PLAY/PAUSE button. The display shows the track currently playing. Skip forward or back through tracks To select the next track, press >> SKIP. If you are on the last track of the disc, the player will move to track 1. To go back to the beginning of the current track press << SKIP once. To go back to the previous track press << Skip/Search twice. To play a particular track, load the disc in the CD player and press >> SKIP until the track number you want is shown in the display. Pause To stop a track temporarily, press the PLAY/PAUSE button. The disc will pause at the current play position. To resume play, press the PLAY/PAUSE button again. GB - 4 Programmed track selection You can set the unit to play a selection of tracks from your disc. [. . . ] Avoid any direct exposure to the laser beam. Use of controls, adjustments or procedures not listed in this guide may result in hazardous exposure. GB - 5 Care & maintenance Cleaning CDs Use a soft cloth to wipe off any fingerprints and dust from the disc surface. Wipe in a straight line from the center to the outside of the disc. Small dust particles and light stains will not affect the quality of sound reproduction. [. . . ]