User manual JWIN JX-CD6000

[. . . ] Doing so is dangerous, as this could result in an electric shock. If the adapter plug is insert into the DC Jack of the Player, the power supply automatically switch to the AC/DC power and the batteries supply will be disconnected. DC OPERATION ALKALINE BATTERY INSTALLATION (NOT SUPPLIED) Insert two AA batteries (not supplied) into the battery compartment on the bottom of the unit. Be sure to observe the proper polarity. CHARGING AND USE OF RECHARGEABLE BATTERIES This unit can fully recharge the specified rechargeable batteries, in approximately 15 hours. The rechargeable batteries (NOT supplied) should be recharged before they are used for the first time or they have not been used for a long period of time (over 60 days). [. . . ] Note: Both 8cm and 12cm discs can be played in the unit. Place only one disc at a time in the CD compartment. TRACK SEARCH · Press the sired track. · Press the · Press the playing. · Press the and button during play to skip to the deto skip to the next track on the disc. to skip to the beginning of the track currently twice or more to skip to previous tracks. FORWARD/REVERSE SEARCH Press and hold the skip ( ) button during play to scan the disc at high speed. When the desired section of the disc is found, release the button. ----forward ----reverse ) while playing, it will scan the current · If you press and hold the skip button ( playing track forward at high speed. ) while playing, it will scan the current · If you press and hold the skip button ( playing track backwards at high speed. BASS BOOST Use the Bass Boost function to increase the bass output when listening with headphones. During bass boost on setting, sometimes, you may hear some distortion, adjust the volume control to a lower level when using the bass boost feature. ON OFF BASS BOOST PROGRAMMED PLAY The tracks on the disc can be programmed for play in any order. (Up to 24 tracks can be programmed. ) During programming, "PROG" flashes in the display. NOTE: Programming is possible in the STOP mode. The "RAND" will appear in the display. The display will show the first track the CD player select. Press the skip button to skip the next random song. To stop the function, press the CD Mode button once more or press the Stop button. THE HOLD FUNCTION It is useful during playing, the function will lock the key on the panel to protect the mistake during playing. During playing slide the HOLD switch to `ON' position, the `HOLD' will appear in the display, the key on the panel will be locked, the panel key is disabled. Slide the HOLD switch to `OFF' position to stop the function. E. 4 THE ANTI-SKIP MEMORY FUNCTION (45SEC. ) The digital anti-skip function uses semiconductor memory to prevent the sound from skipping when the unit is subjected to shocks and vibration during play. When the ESP button is pressed during play, the display and the digital anti-skip function turns on. The digital data equivalent to approximately 3 seconds (45 seconds) of music is stored in a read-ahead memory mark buffer before it is decoded and played. The display changes from the mark, indicating that the data has been stored. When the unit is subjected to a shock during play, the data stored in memory continues to be decoded and continue reading new data. [. . . ] Dirty, scratched or warped discs may cause skipping or noise. Pay attention to the following: Handle the disc only by the edges. To keep the disc clean, do not touch the surface of the disc. Discs should be returned to their cases after use to avoid serious scratches that could cause the laser pickup to skip. [. . . ]