User manual KARCHER SC 2 PREMIUM JAUNE

[. . . ] EN EN EN EN EN EN EN EN EN 5 5 5 6 6 7 8 8 8 Safety Devices ṇ CAUTION Safety devices protect the user and must not be modified or bypassed. Pressure controller The pressure controller keeps the boiler pressure during the operation as constant as possible. The heating is turned off if the maximum operating pressure of 4 bar is reached in the boiler and is reactivated in case of a pressure drop in the boiler due to steam tapping. Safety thermostat The safety thermostat turns off the appliance if the pressure controller fails and the appliance overheats in case of a malfunction. [. . . ] σ Fill the boiler with a maximum of 1 liters of fresh tap water. σ Screw the safety cap back onto the device. σ Insert the mains plug into a socket.  The orange indicator lamp goes out after approximately 8 minutes. Fill up with water Notes  In case of continuous use of commercially available distilled water, no descaling of the boiler is necessary. ρ You can reduce the heating-up time by using warm water. σ Remove the safety lock from the device. illustration  Completely empty the steam boiler to remove existing water. σ Fill the boiler with a maximum of 1 liters of fresh tap water. σ Screw the safety cap back onto the device. Turning Off the Appliance Illustration  Disconnect the mains plug from the socket. Illustration  Push the steam switch until steam discharge stops. Now, the boiler of the appliance is unpressurized. Storing the Appliance Illustration  Put the extension pipes into the large accessory compartments. σ Insert the manual nozzle and detail nozzle onto each extension pipe. σ Attach the big round brush to the small detail nozzle. σ Put the small round brush and nozzles into the medium accessory compartment. σ Hook the floor nozzle into the parking position. EN – 6 11  Wrap the steam hose around the extension pipes and insert the steam pistol into the floor nozzle. Round brush (small) The round brush can be installed onto the detail nozzle as an accessory. Attached brushes can therefore be used to remove heavy soiling. aTTENTION Not suitable for cleaning sensitive surfaces. [. . . ] Depending on model - fold bevore the floor cloth the long way. € Place the cloth ends into the openings and pull them tight. CAUTION Do not insert fingers between the clamps. Parking the floor nozzle Illustration  During work breaks, hook the floor nozzle into the parking holder. [. . . ]