User manual KAWAI FS660

[. . . ] shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from unsuitable use of this product. shall not be responsible for damage, lost profits, etc. , caused by loss of image data because of defects, disassembly, repair or modification of this product by people other than third parties specified by KAWAI IMAGING CORP. reserves the right to alter the features and contents of this publication without obligation or advance notice. For the latest information of product name and numbers etc. , please contact your local service station. [. . . ] 4 Thinly apply the specified silicone O-ring grease to the O-ring. 5 Match the O mark on the battery cap (back side) with the O mark on the flash and while pushing the battery cap, turn gently in a clockwise direction until it can't turn anymore. · While putting the cap back on take special care so that the O-ring does not project from the groove. 6 After replacing the battery cap tightly, turn it back slightly in a counterclockwise direction and align the marks. · After aligning the marks, make sure no O-ring can be seen. 1 2 4 5 +- 6 O Mark Alignment marks O-ring Correct (The O-ring can't be seen) Incorrect (The O-ring can be seen) EN 18 r2090_e_00. book Page 19 Thursday, May 1, 2008 6:29 PM CAUTION · While installing and exchanging batteries make sure to wipe the flash of any water and always use dry hands. Pay especial attention for any drips from hair and wetsuits. · Turn gently and slowly when taking on/off the battery cap. If the cap is turned too quickly the O-ring may get caught and cause a leakage. · When securing the battery cap tightly, make sure to turn it back slightly in a counterclockwise direction and align the flash's mark with the battery cap's mark. If the battery cap is secured too tight beyond the alignment marks, the battery cap may not be removed due to water pressure etc. · Make sure to use the same type of batteries. 2 Verify that the CHARGE lamp lights up. · Replace the batteries if the time it takes for the CHARGE lamp to light up exceeds the following values. Alkaline or oxyride batteries NiMH or lithium batteries 30 sec. or more · If the CHARGE lamp and AUTO CHECK lamp blink simultaneously, it means that the battery capacity is running low. 3 Press the TEST button to test the flash activation. EN 23 r2090_e_00. book Page 24 Thursday, May 1, 2008 6:29 PM Shooting When the flash is connected using the underwater fiber optic cable Following is an explanation of the basic method for taking pictures with the flash connected to a camera's underwater case using the underwater fiber optic cable. Refer to your camera's instruction manual for details about the camera's operation. EN Channel RC mode Group MODE button 1 Press the MODE button on the flash repeatedly to set the flash to RC mode. 2 Set the camera's RC mode to ON and set the camera's built-in flash so as to allow it to be emitted. · Set the flash mode and the flash intensity on the camera. 3 While holding the MODE button pressed down, turn the dial to select the channel and group. Channel : Set the same channel, between 1 and 4, on the camera and flash. Group : You can control up to 3 groups (A, B and C) of flash arrays with different flash modes and other settings. On the electronic flash set in advance the group with which the flash will be emitted. [. . . ] The AF illuminator only works when you use the electronic flash with Olympus Four Thirds System digital SLR cameras. The light control range is not displayed on the control panel. The light control range is not displayed in the following cases: · When the extension tube EX-25 (optional) is used. · When the ISO sensitivity and aperture value are out of the setting range. [. . . ]