User manual KAZ 18155

[. . . ] Do not use air purifier where combustible gases or vapors are present. Do not expose the air purifier to rain, or use near water, in a bathroom, laundry area or other damp location. The air purifier must be used in its upright position. Do not allow foreign objects to enter ventilation or exhaust opening as this may cause electric shock or damage to the air purifier. [. . . ] It should be replaced at least every 3 months. If there are heavy concentrations of odors, smoke, or large particles in the home, you may need to change the carbon pre-filter more often. For instructions on how to replace your pre-filter, refer to section "Removing/Changing the Filters" in this manual. Note: We do not recommend operating the air purifier without the carbon pre-filter. Operation: Model 50150, Light and Reset Filter Indicator/Turn 50200 Off 50250 Series To Reset Filter Indicator · Once the filter has been checked and cleaned or replaced as needed, the filter indicator will need to be reset. · With the unit powered on, press and hold the appropriate filter indicator button down for approximately 10 seconds until the light turns off (Fig. 1 4 Removing/Changing the Filters INSTALL PRE-FILTER BEFORE INITIAL OPERATION. The initial pre-filter is packaged separately to ensure its freshness. BEFORE initial operation, locate the pre-filter in the box, remove it from its packaging and install per instructions below. 2 Open Close · DISCONNECT from power supply before servicing. · Replace filter(s) and re-assemble unit per instructions below. · Plug in and RESET appropriate filter monitor(s). To Remove HEPA Filter for Cleaning: · Unscrew handle counter-clockwise (Fig 2). · Remove the filter assembly (consisting of the HEPA filter and pre-filter) from the internal chamber. · Locate the seam of the pre-filter and carefully separate the fastener to remove the pre-filter from the HEPA filter. · Discard used pre-filter if necessary. · Replace HEPA Filter (there is no top or bottom to filter). · Insert and tighten handle clockwise. To Replace Pre-filter: · Place unit on its side. · Push in on both tabs on base ring to release base (Fig. · Gently remove base from motor assembly. · Install initial pre-filter or replace used one. Wrap pre-filter around Base Ring and attach with fastener provided. [. . . ] DO NOT RETURN TO THE ORIGINAL PLACE OF PURCHASE. DO NOT ATTEMPT TO OPEN THE MOTOR HOUSING YOURSELF, DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE AIR PURIFIER OR PERSONAL INJURY. 7 Storage Five Year Limited Warranty You should first read all instructions before attempting to use this product. This 5 year limited warranty applies to repair or replacement of product found to be defective in material or workmanship. [. . . ]