User manual KAZ 50300

[. . . ] Do not expose the air purifier to rain, or use near water, in a bathroom, laundry area or other damp location. The air purifier must be used in its upright position. Do not allow foreign objects to enter ventilation or exhaust opening as this may cause electric shock or damage to the air purifier. Locate air purifier near the outlet and avoid using an extension cord. [. . . ] For instructions on how to replace your pre-filter, refer to section "Removing/Changing the Filters" in this manual. Note: We do not recommend operating the air purifier without the carbon pre-filter. Once the filter has been checked and cleaned or replaced as needed, the filter indicator will need to be reset. With the unit powered on, press and hold the appropriate filter indicator button down for approximately 10 seconds until the light turns off (Fig. Do not attempt to wash either the carbon pre-filter or the HEPA filter. they are not washable and washing will damage the filters. The only two parts requiring any service are the carbon pre-filter and the HEPA filter. To remove or change either filter, disassemble the unit as shown below: Step 1: Turn the air purifier off and unplug from the wall outlet. Step 2: To open, gently place the air purifier on its side and unscrew the locking mechanism located on the bottom of the unit (Fig. Step 3: Remove the base assembly from the air purifier. Step 4: Remove the filter assembly (consisting of the HEPA filter and pre-filter) from the internal chamber. Step 5: Locate the seam of the pre-filter and carefully separate the fastener to remove the pre-filter from the HEPA filter (Fig. Step 6: Discard used pre-filter if necessary. Step 7: Carefully wrap the pre-filter around the HEPA filter so that the ends meet (Fig. Fasten the ends together with the fastener provided. Use Honeywell Universal Carbon Pre-filter model #38002. Step 8: Place the whole filter assembly into the internal chamber. close the product by replacing the base and tightening the locking mechanism. Step 9: Turn the air purifier into an upright position, plug into a wall outlet and it is ready for operation. Step 10: For models 10590 and 50100, roll forward the Pre-filter Change Calendar 3 months Turn the air purifier OFF and unplug from the wall outlet. After removing the filter assembly from the air purifier (refer to section "Removing/Changing the Filters" in this manual), separate and remove the carbon pre-filter from the HEPA filter and place aside (or discard if pre-filter needs replacement). To vacuum-clean the filter, hold the filter and run a vacuum cleaner with a nozzle or brush attachment along the filter to pick-up the dirt and particles (Fig. [. . . ] Thereafter, while within the warranty period defective product may be returned to Kaz. This warranty does not cover the pre-filter or the HEPA filter except for material or workmanship defects. This warranty does not cover damage resulting from any unauthorized attempts to repair or from any use not in accordance with the instruction manual. Return defective product to Kaz, Incorporated with a brief description of the problem. [. . . ]