User manual KAZ BP 2510

[. . . ] Blood pressure (mmHg) SYS = systole = upper value DIA = diastole = lower value Normal values up to 140 up to 90 Mild hypertension 140 ­ 180 90 ­ 110 Severe hypertension over 180 over 110 What you should know about this blood pressure monitor For accurate measurements, all wrist blood pressure monitors must be positioned at heart level. Example: If the monitor is positioned 20 cm below heart level as shown on the left (e. By putting the arm on a table), the reading you will obtain is approximately 15 mmHg too high. Therefore, the Braun SensorControl has a unique active positioning system: The position sensor arrows on the display guide you to hold your measuring arm in the right position at heart level. [. . . ] Slowly move the hand upward along the upper arm. Move your hand up or down according to the direction of the arrow shown. When you have reached the right measuring position, the display shows a heart symbol and a beep will sound. When the measurement is complete, a beep will sound again, and the reading is displayed: Upper (systolic) value Lower (diastolic) value Pulse Please note: 15 seconds after switching on the appliance, the measuring process will start automatically, even if the appropriate measuring position has not been reached. If at any time, you want to discontinue the measurement, press the I/0 button. Otherwise the product will turn off automatically after 2 minutes. Your blood pressure monitor stores the readings of the last 30 measurements. Storing is done automatically without having to press the memory button after a measurement. Once the memory is full, the oldest values will be overwritten. Recalling stored readings To recall stored readings, first turn the product off, then press the memory button («mem») (B). The number in the upper left corner of the display indicates the memory position (0 being the oldest, 29 the most recent). Repeatedly pressing the memory button will call up one by one all stored readings. By means of the «select» button (D) placed underneath the battery compartment cover, you can de-activate the position sensor (e. If you want to measure while lying down). Please note: Unless you confirm a modified setting by pressing the I/0 button, the appliance will turn off automatically after 2 minutes without adapting the modified setting. Clean the product with a soft, slightly damp cloth. Stains on the cuff (G) can be carefully removed with damp cloth. If used according to the use instructions, periodic recalibration is not required. If at any time, you question the measuring accuracy, please contact a Braun Service Centre. Manufacturing date is given by the LOT number on the back of the product. The first number after LOT represents the last digit of the year of manufacture. The next three digits give the day of the year of manufacture. [. . . ] The guarantee becomes void if repairs are undertaken by unauthorised persons and if original Braun parts are not used. To obtain service within the guarantee period, hand in or send the complete appliance with your sales receipt to an authorised Braun Customer Service Centre. For UK only: This guarantee in no way affects your rights under statutory law. For a reliable blood pressure measurement, make sure that you hold the appliance at heart level. [. . . ]