User manual KAZ HFD-120

[. . . ] Do not expose the air purifier to rain, or use near water, in a bathroom, laundry area or other damp location. The air purifier must be used in its upright position. Do not allow foreign objects to enter ventilation or exhaust opening as this may cause electric shock or damage to the air purifier. Locate air purifier near the outlet and avoid using an extension cord. [. . . ] to RESET the Electronic Filter Check: When the filter monitor light remains on , it is time to check/clean the IFDTM filters and reset the filter monitor , if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED filter check light and hold for approximately 5 seconds until the light turns off (Fig. Depending upon your individual usage (environment and hours used), you may need to check and clean the filters more or less frequently. If the IFDTM filters are cleaned before the filter monitor light turns on, the filter monitor should be reset at the same time. These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent upon the concentration of contaminates going through the system. high concentrations of contaminates such as dust , pet dander and smoking will reduce the useful performance of the filter. OSCILLATION FEATURE To help circulate fresher, cleaner air through the room, this unit has an oscillation feature. To turn Oscillation on, simply press the Oscillation button ( · REMOVING THE FILTERS The IFDTM filters are supplied within the air purifier. While pressing on the notches along the rear grille, pull the grille towards you and remove it (See Fig. Gently push along the edge of the filter frame and pull forward. Place back into the air purifier housing and snap filter grille into place. After removing the IFDTM Filter from the air purifier, lay the filter on a flat surface and run a vacuum cleaner with a nozzle or brush attachment along the filter to pick-up tiny particles. If your IFDTM filter appears to have dirt that has not been removed by tapping and vacuuming, please follow the steps below to wash the IFDTM filter. Turn the power off and unplug the air purifier. Fill a sink with lukewarm water and add a few drops of mild dish soap. Do not leave for an extended period of time. Shake the filter to remove any excess water. Place the filter with the honeycomb side down on a plush towel. Note that the filter may still be discolored even after washing. This is acceptable and will not affect performance. Allow the IFDTM filter to dry for a few hours or overnight. [. . . ] This warranty applies only to the original purchaser of this product from the original date of purchase. At its option, Kaz will repair or replace this product if it is found to be defective in material or workmanship. Defective product should be returned to the place of purchase in accordance with store policy. Thereafter, while within the warranty period defective product may be returned to Kaz. [. . . ]