User manual KAZ HZ-335

[. . . ] To disconnect the heater, first turn controls to the OFF position, then grip the plug and pull it from the wall outlet. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric shock or fire, or damage the heater. To prevent a possible fire, do not block air intakes or exhaust in any manner. Do not use on soft surfaces, like a bed, where openings may become blocked. [. . . ] · Press the F/C button to toggle between Fahrenheit and Celsius. · Press Mode until the Temperature icon blinks. The current room temperature will appear. · Use the Up or Down arrows to set the desired temperature. · The Temperature icon will stop blinking and the current room temperature will reappear after the desired temperature is set. · The heater will turn-off shortly after the desired temperature is reached and the Power light above the display will blink. · The heater will turn back on when the room temperature drops approximately 2 degrees below the desired temperature. The Power light will stop blinking and will remain lit. 2 OSCILLATION POWER: High Power Low Power Power · The Oscillation feature functions in any power or mode setting. · Press the Oscillation button to toggle this feature on and off. Basic Remote LCD Remote REMOTE CONTROL OPERATION (HZ-336 SERIES): Two (2) AAA batteries required. Model HZ-336: Remote Control included when originally purchased. Model: HZ-335: Remote Control may be purchased separately at: www. honeywellconumerproducts. com The Remote Control works the same as the corresponding buttons on the Control Panel. The Control Panel display on the heater will show the appropriate icons when the various functions are activated. · Press Power once to start the heater on High Power, Continuous Run. · Press Power again to change to Low Power, Continuous Run. · Press Power a third time to turn the heater off. MODE: SET TEMPERATURE Set Temperature Mode Adjust Up or Down Basic Remote LCD Remote · Press Mode until the Temperature icon blinks. The current room temperature will appear. · Use the Up or Down arrows to set the desired temperature. · The Temperature icon will stop blinking and the current room temperature will reappear after the desired temperature is set. · The heater will turn-off shortly after the desired temperature is reached and the Power light above the display will blink. · The heater will turn back on when the room temperature drops approximately 2 degrees below the desired temperature. The Power light will stop blinking and will remain lit. 3 MODE: SET TIMER Set Timer When done, plug-in the heater and follow the OPERATION INSTRUCTIONS. [. . . ] This warranty applies only to the original purchaser of this product from the original date of purchase. At its option, Honeywell will repair or replace this product if it is found to be defective in material or workmanship. Defective product should be returned to the place of purchase in accordance with store policy. Thereafter, while within the warranty period defective product may be returned to Honeywell. [. . . ]