User manual KAZ HZ-519

[. . . ] Do not use on soft surface, like a bed, where openings may become blocked. A heater has hot and arcing or sparking parts inside. Do not use it in the areas where gasoline, paint, or flammable liquids are used or stored. Use this heater only as described in this manual. [. . . ] The Power light will stop blinking and will remain lit. BASIC CONTROL PANEL OPERATION: POWER Continuous Run Power Mode 70F o MODE: SET TIMER Timer F/C Power Back-Lit · Press Power once to turn the heater on. · Press Power again to turn the heater off. Mode Back-Lit F/C · Press Mode until the Timer icon blinks. · Use the Up or Down arrows to set an operation time between 1 and 10 hours. · The heater will turn-off when time runs out. 2 FAHRENHEIT/CELSIUS POWER Power Mode Back-Lit F/C Power F/C Temperature Display · F/C feature functions from only the Power or Set Temperature screens. · Press the F/C button to toggle between Fahrenheit and Celsius. Basic Remote LCD Remote · Press Power once to turn the heater on. · Press Power again to turn the heater off. · MODE: SET TEMPERATURE BACK-LIT DISPLAY Temperature Power Mode Mode Back-Lit F/C Adjust Up or Down · The Back-lit feature provides light to the heater display and functions in any power or mode setting. · Press the Back-lit button to toggle this feature on and off. Basic Remote LCD Remote REMOTE CONTROL OPERATION Two (2) AAA batteries required. The HZ-519 is compatible with a Basic or LCD Remote Control which can be purchased separately at: www. honeywellconsumerproducts. com The Remote Control works the same as the corresponding buttons on the Control Panel display on the heater and will show the appropriate icons when the various functions are activated. · Press Mode until the Temperature icon blinks. The current room temperature will appear. · Use the Up or Down arrows to set the desired temperature. · The Temperature icon will stop blinking and the current room temperature will reappear after the desired temperature is set. · The heater will turn-off shortly after the desired temperature is reached and the Power light above the display will blink. · The heater will turn back on when the room temperature drops approximately 2 degrees below the desired temperature. The Power light will stop blinking and will remain lit. 3 ·MODE: SET TIMER Timer Mode · Check for any obstructions. If you find an obstruction, turn the heater OFF and unplug it. Allow the heater to cool completely, then remove the obstruction. Wait at least 10 minutes, then replug in the heater, press Power and follow the OPERATION INSTRUCTIONS. · For more troubleshooting tips, visit our website at: www. honeywellconsumerproducts. com NOTE: IF YOU CONTINUE TO EXPERIENCE A PROBLEM, PLEASE RETURN THE HEATER TO THE PLACE OF ORIGINAL PURCHASE OR SEE YOUR WARRANTY. DO NOT ATTEMPT TO OPEN THE HEATER YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE HEATER OR PERSONAL INJURY. IF YOU HAVE ANY QUESTIONS REGARDING THIS HEATER, PLEASE CALL OR WRITE: Honeywell Consumer Relations Department 250 Turnpike Road Southborough, MA 01772 Toll Free 1-800-332-1110 E-mail: honeywell@protocolusa. com Adjust Up or Down Basic Remote LCD Remote · Press Mode until the Timer icon blinks. · Use the Up or Down arrows to set an operation time between 1 and 10 hours. [. . . ] This warranty applies only to the original purchaser of this product from the original date of purchase. At its option, Honeywell will repair or replace this product if it is found to be defective in material or workmanship. Defective product should be returned to the place of purchase in accordance with store policy. Thereafter, while within the warranty period defective product may be returned to Honeywell. [. . . ]