User manual KAZ HZ-710

[. . . ] If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. This heater draws 12. 5 amps during operation. [. . . ] Use of this heater is not recommended for persons with reduced sensitivity to heat or an inability to react to avoid burns. 19. SAVE THESE INSTRUCTIONS. MODE: SET TIMER BASIC CONTROL PANEL OPERATION: POWER Continuous Run Mode Timer Power Power F/C Mode F/C · Press Mode until the Timer icon blinks. The Hour display will appear · Use the Up or Down arrows to set an operation time between 1 and 10 hours. · The heater will turn-off when time runs out. · Press Power once to start the heater on High Power, Continuous Run. · Press Power again to change to Low Power, Continuous Run. FAHRENHEIT/CELSIUS · Press Power a third time to turn the heater off. Power MODE: SET TEMPERATURE Temperature Mode Power F/C Mode F/C Temperature Display F/C · F/C feature functions from only the Power or Set Temperature screens. · Press the F/C button to toggle between Fahrenheit and Celsius. · Press Mode until the Temperature icon blinks. The current room temperature will appear. · Use the Up or Down arrows to set the desired temperature. · The Temperature icon will stop blinking and the current room temperature will reappear after the desired temperature is set. · The heater will turn-off shortly after the desired temperature is reached and the Power light above the display will blink. · The heater will turn-off when time runs out. Basic Remote LCD Remote · The Back-lit feature provides light to the heater display and functions in any power or mode setting. · Press the Back-lit button to toggle this feature on and off. OSCILLATION (HZ-7020, HZ-710, HZ-7040 SERIES) TROUBLESHOOTING: If your heater shuts off unexpectedly, safety features may have been activated to prevent overheating. If this happens: · Be sure the power cord is plugged into a working electrical outlet. The unit may simply be off because you have reached your desired heat setting. If you find one, turn the heater OFF and unplug it. Wait at least 10 minutes to allow the heater to cool completely before removing any obstruction. When done, plug-in the heater and follow the OPERATION INSTRUCTIONS. For more troubleshooting tips, visit our website at: www. honeywellconsumerproducts. com NOTE: IF YOU CONTINUE TO EXPERIENCE A PROBLEM, PLEASE RETURN THE HEATER TO THE PLACE OF ORIGINAL PURCHASE OR SEE YOUR WARRANTY. DO NOT ATTEMPT TO OPEN THE HEATER YOURSELF. DOING SO MAY VOID YOUR WARRANTY AND CAUSE DAMAGE TO THE HEATER OR PER4 MODE Oscillation Basic Remote LCD Remote · The Oscillation feature functions in any power or mode setting. · Press the Oscillation button to toggle this feature on and off. SONAL INJURY. [. . . ] ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. Some jurisdictions do not allow the exclusion or limitation of incidental or consequential damages or limitations on how long an implied warranty lasts, so the above limitations or exclusions may not apply to you. This warranty gives you specific legal rights, and you also may have other rights which vary from jurisdiction to jurisdiction. This warranty applies only to the original purchaser of this product from the original date of purchase. [. . . ]