User manual KAZ IRT 3020 CO

[. . . ] ⷠUse of this thermometer is not intended as a substitute for consultation with your physician. The following table shows that this normal range also varies by site. Therefore, measurements from different sites should not be directly compared. The following table shows normal ThermoScan ranges by age. [. . . ] After one second a longer beep will signal the end of the measuring process. For the next measurement, remove the used lens filter and put on a new, clean lens filter. clear the display by pushing the «start» button once. Fit the probe snugly into the ear canal, then push the «start» button. The Braun ThermoScan ear thermometer turns off automatically after 60 seconds of inactivity. A measurement taken in the right ear may differ from the measurement taken in the left ear. Therefore, always take the temperature in the same ear. ⷠThe ear must be free from obstructions or excess earwax build-up to take an accurate reading. ⷠExternal factors may influence ear temperatures, including when an individual has: ­ been lying on one ear or the other ­ had their ears covered ­ been exposed to very hot or very cold temperatures, or ­ been recently swimming or bathing. In these cases, remove the individual from the situation and wait 20 minutes prior to taking a temperature. ⷠIf ear drops or other ear medications have been placed in the ear canal of one ear, take the temperature in the untreated ear. If the thermometer is accidentally used without a lens filter, clean the probe tip as follows: Very gently wipe the surface with a cotton swab or soft cloth moistened with alcohol. Once the alcohol has dried completely, a new lens filter can be put on and a temperature measurement taken. if the probe tip is damaged , contact Braun. Use a soft, dry cloth to clean the thermometer display and product exterior. Never submerge this thermometer in water or any other liquid. Store the thermometer and lens filters in a dry location free from dust and contamination and away from direct sunlight. Additional lens filters (LF 40) are available at most stores selling Braun ThermoScan. Situation Solution No lens filter Attach new, clean lens is attached. Ambient temperature is not within the allowed operating range (10 ­ 40 °C or 50 ­ 104 °F). Allow the thermometer to remain for 30 minutes in a room where the temperature is between 10 and 40 °C or 50 and 104 °F. Make sure the probe tip HI = too high and lens are clean and a new, clean lens filter is attached. [. . . ] If at any time you question the accuracy of temperature measurements, please contact Braun Infoline (see page 2). Manufacturing date is given by the LOT number located in the battery compartment. The first number after LOT represents the last digit of the year of manufacture. the last two digits give the week of manufacture. [. . . ]