User manual KAZ IRT 4020

[. . . ] To avoid gross temperature differences, the sensor itself is brought to a temperature close to that of the human body. When the Braun ThermoScan is placed in the ear, it continuously monitors the infrared radiation. The measurement will be finished and the result is displayed, when an accurate reading can be assured. The goal of thermometry is to measure core body temperature which is the temperature of the vital organs. [. . . ] In these cases, remove the individual from the situation and wait 20 minutes prior to taking a temperature. ⷠUse the untreated ear if prescription ear drops or other ear medications have been placed in the ear canal. The last temperature taken is stored in its memory and will be automatically displayed when it is turned on again. To display the stored readings, the thermometer must be turned on. Then press the «I/O» button for at least 1 second. MEM 1), and when releasing the «I/O» button, the stored temperature for that memory number is displayed, together with «MEM». if «I/O» button is pressed too long , the thermometer will be switched off. Each further pressing of the «I/O» button displays the remaining memory numbers (up to MEM 8). MEM 1 is the latest reading, MEM 8 would be the oldest. The memory mode is left automatically after displaying the oldest reading, or after pressing the «I/O» button for at least 1 second. Your Braun ThermoScan is shipped with the Celsius (°C) temperature scale activated. If you whish to switch to Fahrenheit (°F) and/or back from Fahrenheit to Celsius, proceed as follows: (1) Make sure the thermometer is turned off. (2) Press and hold down the «start» button (IRT 4020) or the «I/O» button (IRT 4520). After about 3 seconds the display will show this sequence: «°C» / «SET» / «°F» / «SET» . (3) Release the «start» button / «I/O» button when the desired temperature scale is shown. There will be a short beep to confirm the new setting, then the thermometer is turned off automatically. If the thermometer is ever accidentally used without a lens filter, clean the probe tip as follows: Very gently wipe the surface with a cotton swab or soft cloth moistened with alcohol. After the alcohol has completely dried out, you can put a new lens filter on and measure. if the probe tip is damaged , contact Braun. Use a soft, dry cloth to clean the thermometer display and exterior. Never submerge this thermometer in water or any other liquid. Store thermometer and lens filters in a dry location free from dust and contamination and away from direct sunlight. [. . . ] Practise taking temperatures on yourself and healthy family members to determine their normal temperature ranges. Note: When consulting your physician, communicate that the ThermoScan temperature is a temperature measured in the ear and if possible, note the individual's normal ThermoScan temperature range as an additional reference. How to use Braun ThermoScan To achieve accurate readings, make sure a new, clean lens filter is in place before each measurement. Then wait for the ready signal beep and the ready symbol in the display. [. . . ]