User manual KAZ MA06

[. . . ] Keep cord away from heat, oil, sharp edges or wet surfaces. Do not clean this product with water spray. Do not place where it can fall into water. The Indoor Insect Trap may be placed on furniture, a shelf or on the floor, but always in a vertical position. [. . . ] To turn unit ON, slide the ON/OFF Lever (A) all the way to the right (see Fig. The light and the fan will turn on and Inlet Valve (B) will open. In this position, the Indoor Insect Trap will lure and trap insects. NOTE: in the ON position, the Catch-tray (C) is locked BC cannot be removed. To turn unit OFF, slide the ON/OFF Lever all the way to the left (see Fig. The light and the fan will turn off and the Inlet Valve will be D closed preventing the escape of live insects. In this position, the D Catch-tray is unlocked and can be removed for emptying or ep 6 A Fig. To remove Catch-tray, ensure ON/OFF Lever is in the OFF position. Pull the Catch-tray straight out by slightly pushing in the Finger Grips (D) located on either side of the tray (see Fig 1). To empty Catch-tray, pull the Snap Tab (E) at the back and separate the top and bottom (See Fig 2). Please use caution when emptying the tray; make sure the insects (especially stinging insects) are inactive. If you notice that beneficial insects have been captured, it is your choice to release them outdoors or let them dehydrate in the unit. Clean the Catch-tray as necessary by rinsing under running water and dry with a paper towel. To reassemble Catch-tray, E slide top and bottom together until Snap-Tab is engaged. Be sure ON/OFF Lever is in the OFF position and the Inlet Valve is closed. Slide Catchtray back into unit by aligning ep 8 the bottom on the tracks until Fig. 2 Step 7 BULB REPLACEMENT For maximum effectiveness, replace the bulb (Model B04) every 1500/2000 hours of use (at least once a year) to maintain optimal UV attraction. Even though the bulb's light may be visible to you, its ability to attract insects diminishes over time. Using a #1 Phillips screwdriver, remove the cap screw in the center rim above the NOsquito logo. Twist bulb 90° (See Fig 2a) and pull upward until bulb is removed (See Fig 2b). [. . . ] properly before inserting back into unit. No electrical power or unit turned off. ACCESSORIES PART B04 DESCRIPTION 4 Watt Replacement bulb for MA06 LIMITED WARRANTY STINGER Division of Kaz Inc warranties to the original purchaser that this product is free from defective materials and workmanship for a period of 1 year from date of original date of purchase. Retain your original receipt as proof of purchase. This warranty does not apply to the bulb, nor to, in our judgment, misuse or abuse. [. . . ]