User manual KB ELECTRONICS KBCC-255

[. . . ] This supplement is being supplied with the KBPB and KBCC-R Installation and Operation Manuals (Part Nos. A40210A and A40225A) until the new manuals are available. [. . . ] A40210A and A40225A) until the new manuals are available. The figures below replace the figures in the KBPB and KBCC-R Installation and Operation Manuals. For further assistance, contact our Sales Department toll free, at 800-221-6570. Read Safety Warning SAFETY WARNING! This drive contains electronic Start/Stop circuits which can be used to start and stop the drive. However, these circuits are never to be used as safety disconnects since they are not failsafe. Be sure to follow all instructions carefully. Fire and/or electrocution can result due to improper use of this product. Power Main Speed Potentiometer Forward-Brake-Reverse Switch TB1 P1 P2 P3 S1 S2 S3 S4 + ARMATURE P1 P2 P3 S1 S2 S3 S4 A1 TB1 FWD-BRK-REV SWITCH REV BRK FWD HIGH WIPER LOW MAIN SPEED POTENTIOMETER Forward-Brake-Reverse and Run-Brake-Jog Switches with Main Speed Potentiometer P1 P2 P3 S1 S2 S3 S4 TB1 FWD-BRK-REV SWITCH REV BRK FWD HIGH WIPER LOW MAIN SPEED POTENTIOMETER JOG BRK RUN RUN-BRK-JOG SWITCH FWD BRK REV FWD-BRK-REV SWITCH L2 A2 AC LINE INPUT L1 CHASSIS TB3 GROUND (EARTH) Run-Brake and Forward-Reverse Switches Forward-Brake-Reverse Switch with Adjustable Forward and Preset Reverse Speed TB1 P1 P2 P3 S1 S2 S3 S4 FWD-REV SWITCH REV RUN-BRAKE SWITCH FWD P1 P2 P3 S1 S2 S3 S4 TB1 HIGH WIPER LOW MAIN SPEED POTENTIOMETER Forward-Brake-Reverse and Run-Brake-Jog Switches with Main Speed Potentiometer and Remote Jog Potentiometer TB1 Tach-Generator Feedback Connections 50 Volts per 1000 RPM Tach-Generator 7 Volts per 1000 RPM Tach-Generator P1 P2 P3 S1 S2 S3 S4 FWD-BRK-REV SWITCH REV RUN-BRK-JOG SWITCH BRK FWD RUN HIGH WIPER LOW MAIN SPEED POTENTIOMETER BRK JOG "B" TERMINAL (ON KBMM) "T" TERMINAL (ON KBMM) TB2 F+ F- TB2 F+ F- + TACH-GENERATOR + TACH-GENERATOR REMOTE JOG POTENTIOMETER KB ELECTRONICS, INC. 12095 NW 39th Street, Coral Springs, FL 33065-2516 · (954) 346-4900 · FAX (954) 346-3377 Outside Florida Call Toll Free (800) 221-6570 · info@kbelectronics. com www. kbelectronics. com (A40150) ­ Rev. This control must be mounted in an enclosure. Care should be taken to avoid extreme hazardous locations where physical damage to the control can occur due to moisture, metal chips, dust, and other contamination including corrosive atmosphere. If such contamination is present, special enclosures may be required such as NEMA type 4X. Failure to observe these instructions could cause an electrical shock, fire, or explosion in this product or the products used with this product. Do not use this control in an explosion-proof application. You must read the Safety Warning which accompanies this product. KB ELECTRONICS, INC. (A40150) ­ Rev. [. . . ] Failure to observe these instructions could cause an electrical shock, fire, or explosion in this product or the products used with this product. Do not use this control in an explosion-proof application. [. . . ]