User manual KENMORE 625.381560

[. . . ] OWNER'S MANUAL Reverse Osmosis System MODEL NO. 625. 381560 UltraFilter 450 Caution: Read and follow all safety rules and operating instructions before first use of this product. Questions ?Visit www. KenmoreWater. com or call toll free 1-800-426-9345 (M - F, 7AM - 8 PM CST) Repair or Parts ?Call toll free 1-800-366-7278 See back cover for other Sears service numbers. [. . . ] Run the other end of the yellow tube to the fitting on top of the storage tank. This will occur in the sanitizing step. CONNECT BLUE TUBE TO REVERSE OSMOSIS ASSEMBLY 1. Run the other end of the 3/8" blue tube to the blue collet on the right side of the Reverse Osmosis filter assembly. Pull on the tube to be sure it's held firmly in the fitting. CONNECT GREEN TUBE TO COLD WATER SUPPLY PIPE 1. Run one end of the 1/4" green tube to the fitting on the water supply pipe. Run the other end of the green tube to green collet to the fitting on the left side of the Reverse Osmosis filter assembly. Pull on the tube to be sure it is held firmly in the fitting. CONNECT BLACK TUBE FROM REVERSE OSMOSIS FAUCET TO DRAIN ADAPTER 1. Locate the 30" length of 3/8" black tube. The other end needs to be attached to the black collet on the sink drain adapter. Cut this tube as needed to route in as straight of a run as possible, without loops, dips, low spots or kinks. Pull on the tube to be sure it is held firmly in the fitting. CONNECT RED TUBE TO REVERSE OSMOSIS FAUCET The red tube connection was completed in the faucet assembly steps. Questions?Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater. com 15 Step 7 - Sanitize, Test and Purge System SANITIZE THE SYSTEM Sanitizing is recommended immediately after installation of the Reverse Osmosis system. It's also recommended after servicing inner parts. It is important that the person installing or servicing the system have clean hands while handling inner parts of the system. Complete the following steps to sanitize the system. Turn off the water supply to the Reverse Osmosis system. Locate the eyedropper that is included in package and common household bleach (5. 25%). of bleach into open end of yellow tank tubing. Handle bleach according to bleach manufacturer's recommendations. Connect yellow tank tubing to tank connector. Sanitizing the system will be completed during the pressure test and purging steps on the following page. NOTE: The bleach must be removed from the system before drinking the water. [. . . ] Send treated and untreated water samples to a water analysis lab for testing. It is important to test both the treated and untreated water to determine system performance. If the TDS is not within the system's performance guidelines, replace the prefilter, post filter and RO membrane cartridges. Problem: Continual water flow to drain and no product water. Cause: Missing flow control insert in red drain tube Correction: or its corresponding port. Call The Kenmore Water Line 1-800-426-9345 or visit KenmoreWater. com 24 Troubleshooting Problem: Water leaking from faucet airgap hole. Cause: Drain side of faucet airgap (3/8" black tub- Correction: ing) plugged, restricted or incorrectly connected to drain point. [. . . ]