User manual KENWOOD C-V750

[. . . ] AV CONTROL CENTER C-V750 INSTRUCTION MANUAL KENWOOD CORPORATION B60-3214-00 CH (T) MC 98/12 11 10 9 8 7 6 5 4 3 2 1 97/12 11 10 9 8 7 6 Before applying power C-V750 (En/T) 2 Before applying power Units are designed for operation as follows. 3 Caution : Read this section carefully to ensure safe operation. Europe and U. K. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 230 V only For the United Kingdom Factory fitted moulded mains plug 1. For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse. [. . . ] 1 VCR Frequency display 2 AUX 3 TAPE 1 / MD 4 TUNER (frequency display) 5 CD 6 DVD-D 7 DVD-A / 6ch INPUT 8 LD -D 9 LD -A 0 CABLE / SAT ÷ The previously tuned frequency is displayed. 1 FM 2 MW 3 LW 8 9; ) ) MHz FM -- 3 Preset radio stations by AUTO MEMORY. Main unit In a few minutes, the stations with which RDS broadcast is received are stored in order beginning from preset channels "01" (up to 40 stations can be preset). Press the A. MEMO key. A. MEMO AUTO The "FM" indicator should light. AUTO ME MO Blinks When the number of stations providing RDS broadcasting is less than 40, some of other FM stations will be preset in the vacant channels. ÷ If stations have already been stored in preset channels, the same number of these preset channels as the number of stations are cleared and replaced with the data of the newly preset stations. Receiving a preset RDS station GRC 123 Enter the preset number (max. 40) of the desired RDS station. 456 789 0 +10 Press numeric keys in the order as described below: To enter "15" . . . . . . . . . . . 0 ENTER 5 ENTER To enter "20" . . . . . . . . . . . 0 ENTER 0 ENTER ) ENTER ÷ If you commit a mistake in entering the digit of 10, press the 0 key several times to return to the original display and re-enter the preset number from the beginning. ÷ Press the RDS DISPLAY key to change the displayed information. RDS FM B B C 1 FM RDS (Radio Data System) C-V750 (En/T) The AUTO MEMORY function gives precedence to RDS stations and assigns them from preset number 1. Therefore, when it is required to preset RDS stations as well as non-RDS stations, execute the AUTO MEMORY operation first then proceed to the manual memory operation of non-RDS stations. Order of radio station presetting Other stations than the RDS stations can be stored in the preset memory by presetting them after the RDS stations preset by AUTO MEMORY as shown below or overwriting the RDS stations preset in some preset numbers. Preset number 12 39 40 1 AUTO MEMORY RDS stations (~ FM stations) 29 Preparation ÷ Select the TUNER input. & ÷ Display the Tuner operation menu. & ~ 2 Manual memory FM stations or LW or MW stations Storing radio stations manually in preset memory GRC 1 Select the receiving band. 3 Press the Memory key during receiving a station. ÷ Apart from the auto memory function, RDS stations can also be stored manually in the preset memory. ÷ In the manual memory storage operation of radio stations, it may take a few minutes after the Memory key is pressed till the memory display starts to blink depending on the receiving condition. Lights up (for 10 sec. ) Blinks (for 10 sec. ) Memory / 10key Pad Proceed to step 4 within 10 sec. have elapsed, press the Memory key again. ) ENTER MEMO FM Memory ENTER )- 8 9; ) ) MHz 4 Select one of the preset numbers from 1 to 40. 123 456 789 0 +10 ENTER Press the numeric keys in the following order. 0 ENTER 5 ENTER To store in "20" . . . . . . . 0 ENTER 0 ENTER ) ENTER ÷ Repeat steps 1, 2, 3, 4 for each of the stations to be stored in memory. ÷ If a station is stored in a preset number which has already stored a station memory under it, the previous memory is replaced by the new memory content. ÷ If RDS stations are stored manually in the preset memory, the PS may not be included in the memory depending on receiving conditions. Receiving a preset station GRC Memory / 10key Pad ENTER Press the numeric keys in the following order. 0 ENTER 5 ENTER To recall "20" . . . . . . . . . . . 0 ENTER 0 ENTER ) ÷ If you make a mistake in entering the figure of 10, press the 0 key repeatedly until the original display is shown, then enter the correct number. Preset number stored in memory 123 Enter the preset number (max. [. . . ] § ÷ Install the outdoor antenna away from the road. ÷ Turn off the power to the appliance. ÷ Install the system farther away from the TV set. ÷ Preset the stations by auto memory again. [. . . ]