User manual KENWOOD CAW-CV2440

[. . . ] · If the unit starts to emit smoke or strange smells, turn off the power immediately and consult your Kenwood dealer. · Make sure not to get your fingers caught between the faceplate and the unit. · Be careful not to drop the unit or subject it to strong shock. The unit may break or crack because it contains glass parts. [. . . ] · If you are tuned to a station that is not a traffic information station itself but which provides EON services, you can still have traffic information received. The EON indicator lights up when EON signals are being received. Sometimes stations in the same network broadcast different programmes or use different programme service names. Auto TP Seek Function When the TI function is on and poor reception conditions are experienced when listening to a traffic information station, another traffic information station with better reception will be searched for automatically. This function is on, when unit is first powered on. Traffic Information Function You can listen to traffic information. If you are listening to tapes or discs, they will continue playing until a traffic bulletin is broadcast. Turning TI function On/Off: Press the TI button to turn the function on and off. When the function is on, the TI indicator is turned on. When a traffic information station is being received, the TP indicator will turn on. When none is being received, the indicator will blink on and off. When a traffic bulletin begins to be broadcast, the TA indicator will turn on, and reception will begin at the preset volume. If you are listening to a tape when a traffic bulletin begins, they will automatically be turned off. When the bulletin ends or poor reception is experienced, the tape or disc will begin playing again. NOTE Turning Auto TP Seek Function On/Off: 1 Hold down the MENU button for one second or more. "MENU" is displayed and the menu mode is turned on. 2 Press the ¢ button repeatedly until the Auto TP Seek function appears in the display. "MENU" is displayed and the menu mode is turned on. · You can select the type of programme directly by pressing a preset button. The buttons are factory-set to the following type of programmes: 1. Varied NOTE Changing the Preset Button Settings for Programme Type After selecting the type of programme to be stored in a certain preset button, hold down that button for two seconds or more. The previously stored data for that button are erased and the new programme type is stored. 2 Press the ¢ button repeatedly until "PTY" appears in the display. Press the 4 button to search in the other direction. 3 Press either the AM button or FM button. The PTY indicator will turn on, and the Programme Type Selection (PTY) Mode entered. If you make no key input in 30 seconds, the mode will automatically turn off. NOTE 5 Seeking the selected programme type · You cannot use this function whilst the traffic information function is turned on. · The time is not displayed until you have turned off the programme type function. NOTE Changing the Display Language to French or German In the PTY mode, hold down the CLK button for one second or more to display the name of the language currently used. If you want to change the language, press the preset button for the desired language and then the CLK button. English is #1, French is #2, and German is #3. Press the 4 or ¢ button to make a seek of frequencies with your selected type of programme. If your selected type of programme is found, the name of the station is displayed and the station is tuned into. The PTY indicator blinks in the display for about 30 seconds. [. . . ] Before calling service, first check the following table for possible problems. PROBLEM The power does not turn on. POSSIBLE CAUSE The fuse has blown. No ACC position on vehicle ignition. SOLUTION After checking for short circuits in the cables, replace the fuse with one having the same rating. Connect the same cable to the ignition as the battery cable. Reset the fader and/or balance settings. [. . . ]