User manual KENWOOD CAW-HD2480

[. . . ] THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USER TO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONS IN THE LITERATURE ACCOMPANYING THE APPLIANCE. ESPAÑOL ITALIANO Introduction CAW-HD2480 (EN) 3 Unpacking Unpack the unit carefully and make sure that all accessories are put aside so they will not be lost. Examine the unit for any possibility of shipping damage. If your unit is damaged or fails to operate, notify your dealer immediately. If your unit was shipped to you directly, notify the shipping company without delay. [. . . ] Please adjust the controls so that you get optimal sound at the room location at which you normally listen. FRANÇAIS 1. Adjusting the Volume VOLUME Raise Lower Adjust the volume by turning the VOLUME dial. Adjust so that you get a good balance with satellite speakers. MIN MAX DEUTSCH 2. Adjusting the Turnover Frequency 1 POWER switch Press this switch to set the subwoofer's power on or off. 2 POWER indicator Indicator lights up when power is on. 3 VOLUME adjuster dial 4 PHASE switch 5 TURNOVER FREQUENCY adjuster dial TURNOVER FREQUENCY Raise Lower NEDERLANDS 80Hz 400Hz Use the TURNOVER FREQUENCY dial to adjust the cutoff frequency (the highest frequency reproduced by the subwoofer). Again, adjust so that you get a good balance with satellite speakers. Appropriate adjustment depends on the type of the sound you are reproducing (musical genre, movie soundtrack, etc. ). ITALIANO 3. Switching the Phase PHASE NOR. REV. Normal ESPAÑOL Reverse Try switching the phase if you encounter either of the following problems. · If the interaction of subwoofer and speakers is producing an unnatural bass. · If the bass volume at the room location at which you normally listen seems unnaturally low, possibly as a result of the room acoustics or the positioning of the subwoofer. Important Operating Notes CAW-HD2480 (EN) 15 Satellite Speakers 1. Remove the arm. Remove the arm. FRANÇAIS 1 Loosen the two arm screws (one screw on each side of the arm) and pull the arm out. · Unplug the cord from the jack before removing the arm. 2 Loosen the two arm screws further to remove them from the arm holders. DEUTSCH Loosen the screws. At time of shipping, the arm is mounted at angle D. 3. Insert and fasten the arm. 1 Fit the arm through the openings in the arm holders and adjust to the desired height. Then tighten the two arm screws to lock the arm in place. 3 Reconnect the speaker cord to the jack. NEDERLANDS Arm holders Remove the screws from the arm holders. ITALIANO ESPAÑOL You may now want to readjust the angle of the speaker on the arm. You can do this by loosening the screw holding the speaker to the arm, repositioning the screw, and then retightening it. See "Adjusting the Speaker Angle, on page 8. " 18 Other Ways to Set Up the Satellite Speakers CAW-HD2480 (EN) As an alternative to the standard setup, you can also mount the satellite speakers in any of the following configurations. · Sideways on the stand ("Offset mount") · On the wall ("Wall mount") · Without the stand ("Clip-on mount") 2. [. . . ] 50 mm (2 ") Cone type Nominal Impedance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Peak Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 60 W Maximum Input Power . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 40 W Sensitivity . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 80 dB/W at 1 m Frequency Response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]