User manual KENWOOD CS7070-ES

[. . . ] It will help you to obtain the peak performance for which the speakers were designed. Use this speaker system as the center speaker. Other speakers are to be purchased separately. Record the serial number, found on the back of the unit, in the spaces designated on the warranty card, and in the space provided below. [. . . ] Suffocation ­ After taking the unit out of the polyethylene bag, be sure to dispose of the polyethylene bag out of the reach of children. Otherwise, they may play with the bag, which could cause hazard of suffocation. Water and moisture ­ The appliance should not be used near water - for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, etc. Heat ­ Do not install the unit near a source of heat, such as radiators, or under direct sunlight. Modification ­ Do not attempt to open or modify the unit, for this could cause fire hazard or malfunction. Cleaning ­ Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Abnormal smell ­ If an abnormal smell or smoke is detected, immediately turn the power OFF and unplug the appliance from the wall outlet. This center speaker include magnetic shielding and can therefore be installed close to a TV set. Note, however, that placing the speaker too close to a CRT type TV may in some cases produce distortion in the color reception. in such case , turn on the TV and check that color reproduction is normal. If color is distorted, turn the TV off for 15 to 30 minutes, then turn it back on and check again. (This allows the TV's degaussing circuitry to correct for the magnetic field from the speaker. ) If distortion is still present, move the speaker further from the TV. Place the speaker on the floor or on a shelf or other horizontal stable surface. Keep in mind that speaker is not fixed into place, so be careful to avoid knocking it over. The cushions prevent the speaker from sliding, and dampen its vibrations. This speaker include mount hole for wall mounting. You need to set two screws into the wall at the appropriate distance so that you can hang the speaker from both mount holes. 1 Screw two screws into the walls 300 mm (11-13/16 inches) apart, making sure that screws are horizontally level. Screw each screw only part way in, so that the screw projects 9 to 11 mm (3/8 to 7/16 inches) outward from the wall surface. [. . . ] Be sure to turn off your amplifier before connecting or disconnecting speaker. To ensure safe and reliable operation, be sure that your amplifier or receiver (audio video control center) is able to work with 8-ohm speaker. 2 Insert the conductor Wire with white line The speaker wire can also be connected to the speaker by using banana plugs which are commercially available in audio stores. To use the banana plug connection, tighten the screws on the speaker terminals before inserting the banana plug. [. . . ]