User manual KENWOOD DNX7330BT

[. . . ] This is due to the characteristics of mechanism the product is equipped with. When the product is first powered on works . 6 2 DNX SERIES    DFPKA$ properly, the front panel will automatically move into the position (initial setting angle) shown in (Fig. 2) After the Installation After the installation, perform the Initial Setup by referring to the instruction manual. [. . . ] €¢ If the fuse blows, first make sure the wires aren’t touching to cause a short circuit, then replace the old fuse with one with the same rating. €¢ Insulate unconnected wires with vinyl tape or other similar material. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires or the terminals. €¢ Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the wires or ground them to any metal part in the car. €¢ When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the - connector to a rear output terminal. €¢ After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. €¢ Mount the unit so that the mounting angle is 30° or less. €¢ This unit has the cooling fan (page 5) to decrease the internal temperature. Do not mount the unit in a place where the cooling fan of the unit are blocked. Contact your Kenwood dealer for details. TV Tuner (Optional Accessory) TV ANTENNA INPUT Connection cable (Included in the TV tuner)   TO MONITOR UNIT English 7  DFPKA$ Installing the GPS Antenna GPS antenna is installed inside of the car. It should be installed as horizontally as possible to allow easy reception of the GPS satellite signals. To mount the GPS antenna inside your vehicle: 1. Peel the backing off of the adhesive on the bottom of the metal plate (accessory @). Press the metal plate (accessory @) down firmly on your dashboard or other mounting surface. You can bend the metal plate (accessory @) to conform to a curved surface, if necessary. Check the installation position of the microphone (accessory #). Remove oil and other dirt from the installation surface. Wire the microphone cable up to the unit with it secured at several positions using tape or the like. ¤ • Depending on the type of car, reception of the GPS satellite signals might not be possible with an inside installation. [. . . ] Accessory 7 Accessory 0 English 9    DFPKA$ Installation for Monitor/Player Unit Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. „ Make sure that the unit is installed securely in place. If the unit is unstable, it may malfunction (eg, the sound may skip). Installation on Toyota, Nissan or Mitsubishi Car using Brackets Accessory 8 (M5x6mm) or Accessory 9 (M5x7mm) Car Bracket Accessory 8 (M5x6mm) or Accessory 9 (M5x7mm) 10 DNX SERIES    DFPKA$ Removing Monitor/Player Unit Removing the Hard Rubber Frame (escutcheon) 1. [. . . ]