User manual KENWOOD DP-SE7

[. . . ] Before connecting the power cord to your AC outlet, make sure that the setting position of this switch matches your line voltage. If not, it must be set to your voltage in accordance with the following direction. AC voltage selector switch AC 110­ 120V Note: Our warranty does not cover damage caused by excessive line voltage due to improper setting of the AC voltage selector switch. AC 220­ 240V Move switch lever to match your line voltage with a small screwdriver or other pointed tool. For the United Kingdom Factory fitted moulded mains plug 1. For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse. The fuse cover must be refitted when replacing the fuse in the moulded plug. [. . . ] ÷ Optical fiber cables available on the market may not always be able to be used with this player. If your cord cannot be used with this unit, consult the store from which you purchased the cord or your nearest dealer. Optical fiber cable Adjusting the output levels of the output jacks and headphone output (only for DPF-3010/2010) The OUTPUT level (UP/DOWN) keys of the remote control unit can adjust the output levels from the LINE/OUT jacks and PHONES jack (DPF-3010 only) of the unit. SINGLE TIME OUTPUT DOWN UP _1 2 d b Output level REMOTE CONTROL UNIT RC-P0305 To use the headphone (only for DPF-3010) Connect a stereo headphone to the PHONES jack of the CD player. Adjust the sound volume using the remote control unit. ÷ It is not favorable for the sound quality to decrease the output level from this unit too much. Use these keys for coordination with other line levels. ÷ Adjusting the headphone output level also changes the LINE/OUT level. Do not adjust the output level from this unit particularly during recording. ÷ Please note that the sound output is at the maximum level when the power is turned on. DPF-3010/2010/1010 (En) 8 SYSTEM CONTROL CONNECTIONS Connecting system control cords after connecting a KENWOOD audio component system lets you take advantage of convenient system control operations. There are two KENWOOD system control modes. Make connections according to the groups of terminal symbols shown below. [XS8] Mode : lets you combine F, f, and terminals terminals only [SL16] Mode : for SYSTEM CONTROL SYSTEM CONTROL SYSTEM CONTROL This unit is compatible with both [XS8] and [SL16] modes. In this case, leave the unit for a few hours with the power left ON, and restart the operation after the condensation has dried up. Be specially cautious against condensation in a following circumstance: When this unit is carried from a place to another across a large difference in temperature, when the humidity in the room where this unit is installed increases, etc. Controls and indicators DPF-3010/2010/1010 (En) 10 REPEAT indicator CCRS indicator EDIT indicator SINGLE TIME indicator TOTAL TIME indicator Program check indicator TRACK PGM REPEAT TRACK NO. CCRS EDIT P. C. SINGLE TOTAL TIME TIME TRACK mode indicator Program mode indicator 88 _8 8 : 8 8 12345 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Pause indicator Play indicator The figure shows an example for the DPF-3010 Play track No. indicator TIME indicator, program No. Output level indicator Music calender DISPLAY 1 2 34 5 6 78 STOP PLAY/PAUSE 6 0 ON/STANDBY 1 4 7 EDIT CLEAR TIME DISPLAY 0 2 5 8 3 7 4 P. MODE CHECK PEAK SEARCH 6 ¢ ¡ RANDOM 1 9 REPEAT PHONES +10 9 0 !@ # $ % ^ & * The keys with the same name as those on the remote control unit operate the same way as the remote control unit. 1 ON/STANDBY ( 2P . MODE key ) switch @ $ %( ( @ @ @ # 7 0 EDIT key Press to select the edit recording mode. * %( # !CLEAR key Press to clear the contents of a program. 3 CHECK key Press to display the programmed contents in order. @ TIME DISPLAY key Press to switch the time display mode. 4 PEAK SEARCH key 5 Open/Close key (0) Opens and closes the disc tray. # Remote control light sensor (DPF-3010/2010 only) $ Disc tray Load the disc to be played back. 6 STOP key (7) 7 PLAY/PAUSE key (6) Each time the key is pressed, playback and pause switch each other. % Numeric keys Use the numeric keys to select the desired track. ^ REPEAT key Press to start repeated playback. & RANDOM key Press to start random playback. * Search keys (1, ¡) Fast forwards or fast reverses the track. 8 Skip keys (4, ¢) Press to skip to the beginning of another track. 9 PHONES jack (DPF-3010 only) Use to connect (optional) headphones. Operation of remote control unit (DPF-3010/DP-SE7 only) DPF-3010/2010/1010 (En) The keys with the same name as those on the main unit operate the same way as the main unit. The keys marked * are provided only on the remote control unit. 1 Program-related and other keys ) RANDOM key REPEAT key ^ P . MODE key $ TIME DISPLAY key # EDIT key * CHECK key %( CLEAR key %( *2 OUTPUT (DOWN, UP) key 3 Numeric keys ( 1 ~ ) , 0 ) 4 Basic function keys Skip keys (4, ¢) Search keys (1, ¡) Stop key (7) Play/Pause key (6) 7 # 11 RANDOM 1 DISC SELECTOR 2 3 REPEAT 4 5 DISC SKIP 1 P. MODE 1 2 3 TIME DISPLAY 4 5 6 EDIT 7 8 9 3 CHECK 0 +10 # # @ @ CLEAR 7 6 4 OUTPUT DOWN UP ¢ ¡ 4 2 1 REMOTE CONTROL UNIT RC-P0305 Model: RC-P0305 Infrared ray system Loading batteries 1 Remove the cover. 3 Close the cover. 2 1 2 1 ÷ Insert two AA-size (R6) batteries as indicated by the polarity marking. Operation After plugging in the power cord, press the ON/STANDBY ) switch of the main unit to turn the unit ON. When the ( unit is turned ON, press the key of the function to be operated. Remote control light sensor 6m 30 30 ÷ When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys. REMOTE CONTROL UNIT Operating range (Approx. ) RC-P0305 Notes 1. The supplied batteries are intended for use in operation checks. [. . . ] Compact disc digital audio system Laser . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Semiconductor laser [ D/A Convertors ] D/A Conversion . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Bit Oversampling . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 fs (352. 8 kHz) [ Audio ] (for DPF-3010) Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]