User manual KENWOOD DPC-X337

[. . . ] Part names Unit Display Repeat mode indicator Ramdom mode indicator Program mode indicator Intoro scan indicator Specifications System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Compact disc digital audio system Laser . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Semiconductor laser Audio Frequency response . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20 Hz to 20 kHz, 3 dB PHONES output level (32, 1 kHz ) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Before calling for service, check the items shown in the following table again. (If you request servicing due to the reasons shown in the table, the service may be charged in some cases. ) Symptom Pressing a key cannot initiate an operation or turn the unit on. Cause Remedy Maintenance Simple care Care of lens When the lens in the pick-up gets dirty, malfunctions including the impossibility of playback may occur. The lens should be cleaned using a commercially available camera lens blower, etc. Do not touch the lens to prevent damaging the mechanism. Also do not use a lens cleaner or disc cleaner product. Care of main unit When the unit gets dirty, clean with a soft, dry cloth. If the unit is stained seriously, a moistened cloth can be used. Do not use thinner, benzine, alcohol, etc. for these agents may cause discoloration. Cleaning the plug Wipe the headphone plug with a soft cloth to keep it clean. A dirty plug may cause noise or malfunction. Cleaning If fingerprints or foreign matter become attached to the disc, lightly wipe the disc with a soft cotton cloth (or similar) from the center of the disc outwards in a radial manner. Storage When a disc is not to be played for a long period of time, remove it from the CD player and store it in its case. The HOLD switch is set to on Set the switch to off (HOLD (HOLD On). Replace the two alkaline batteries, or recharge the rechargeable batteries. Place the disc with the labeled side up. Condensation has occurred in- Leave the unit for about 1 hour side the unit. The headphones are connected Insert the plug securely into the incompletely. The headphones are connected Insert the plug securely into the to LINE OUT jack PHONES jack. The volume is set to the mini- Adjust the volume on the unit. A strong vibration that exceeds the capacity of the D. A. S. C. Place the unit in a place not subject to vibration. [. . . ] peat or Intro Scan playback. 3Start playback. When the programmed contents are to be changed further, repeat steps 2 and 3 . When the HOLD switch on the unit is switched on (HOLD On), the unit's keys cannot be operated. Battery duration indicator The duration at which the battery indicator starts to blink is variable depending on the type of battery used. Battery duration indicator Battery Type Blinking Timing Treatment Rechargeable batteries When the batteries is nearly exhausted. In a while, the power will be turned off automatically. Playback is possible while the indicator is blinking. When using a rechargeable battery which is new or which has not been used for more than 2 months, the operating period may be shorter than nomal. [. . . ]