User manual KENWOOD DPF-1030

[. . . ] CD PLAYER DPF-1030 DPF-2030 INSTRUCTION MANUAL KENWOOD CORPORATION B60-4517-08 (EN) Introduction Before applying power 2 Units are designed for operation as follows. Caution : Read this section carefully to ensure safe operation. Australia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 230 V only *Other countries . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110-120 / 220-240 V switchable *AC voltage selection AC voltage selector switch The AC voltage selector switch on the rear panel is set to the voltage that prevails in the area to which the unit is shipped. [. . . ] Also, the simple CCRS operation lets you make great recordings from CD. See the operating instructions supplied with your cassette deck and MD recorder for details. Maintenance Disc handling precautions Handling Hold the discs so that you do not touch the playing surface. Discs which can be played with this unit DVD (12 cm, 8cm), CD (12 cm, 8 cm), VCD, and the audio part of CDV, CDG, CD-EG and CD-EXTRA. Use discs that comply with the IEC standard, for example a disc carrying marking on the label surface. the COMPACT DIGITAL AUDIO 9 Label side Playing side Sticker Never play a cracked or warped disc During playback, the disc rotates at high speed in the player. Therefore, to avoid danger, never use a cracked or deformed disc or a disc repaired with tape or adhesive agent. Please do not use discs which are not round because they may cause a malfunction. Do not attach paper or tape to either the playing side or the label side of the discs. Sticky paste Cleaning If fingerprints or foreign matter become attached to the disc, lightly wipe the disc with a soft cotton cloth (or similar) from the center of the disc outwards in a radial manner. Disc accessories The disc accessories (stabilizer, protection sheet, protection ring, etc. ) which are marketed for improving the sound quality or protecting discs as well as the disc cleaner should not be used with this system because they may cause malfunction. Storage When a disc is not to be played for a long period of time, remove it from the player and store it in its case. Cleaning Do not use volatile solvents such as alcohol, paint thinner, gasoline, or benzine, etc. Do not use contact cleaners because it could cause a malfunction. Be specially careful against contact cleaners containing oil, for they may deform the plastic components. Note related to transportation and movement Before transporting or moving this unit, carry out the following operations. Turn the power ON but do not load a disc. Verify that the display shown appears. TRACK no d1 SC 12345 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 3. Wait a few seconds and set the unit to POWER OFF mode. Caution on condensation Condensation (of dew) may occur inside the unit when there is a great difference in temperature between this unit and the outside. This unit may not function properly if condensation occurs. In this case, leave the unit for a few hours with the power left ON, and restart the operation after the condensation has dried up. Be specially cautious against condensation in a following circumstance: When this unit is carried from a place to another across a large difference in temperature, when the humidity in the room where this unit is installed increases, etc. Controls and indicators 10 REPEAT indicator CCRS indicator EDIT indicator A B Program check indicator TRACK PGM SINGLE TIME indicator TOTAL TIME indicator REPEAT TRACK NO. CCRS EDIT P. C. TRACK mode indicator Program mode indicator SINGLE TOTAL TIME TIME 88 Play track No. indicator _8 8 : 8 8 12345 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 Pause indicator Play indicator The figure shows an example for the DPF-2030 TIME indicator, program No. Output level indicator Music calender DISPLAY 1 2 34 5 6 7 8 POWER OPEN/CLOSE 0 - ON ­ OFF 7 4 6 ¢ ¡ RANDOM P. MODE PHONES EDIT CHECK PEAK SEARCH 1 REPEAT CLEAR TIME DISPLAY *9 0 !@ # $ % ^ & The keys with the same name as those on the remote control unit operate the same way as the remote control unit. 1 POWER switch 2P . MODE key Press for program playback. @ $ %( ( @ @ @ # *9 PHONES jack (DPF-2030 only) Use to connect (optional) headphones. 7 * %( # !@ ^ ) # 3 CHECK key Press to display the programmed contents in order. 0 EDIT key Press to select the edit recording mode. 4 PEAK SEARCH key 5 Open/Close key (0) Opens and closes the disc tray. !CLEAR key Press to clear the contents of a program. @ TIME DISPLAY key Press to switch the time display mode. 6 STOP key (7) 7 PLAY/PAUSE key (6) Each time the key is pressed, playback and pause switch each other. # Remote control light sensor (DPF-2030 only) $ Disc tray Load the disc to be played back. % REPEAT key Press to start repeated playback. ^ RANDOM key Press to start random playback. & Search keys (1, ¡) Fast forwards or fast reverses the track. 8 Skip keys (4, ¢) Press to skip to the beginning of another track. Operation of remote control unit (DPF-2030 only) The keys with the same name as those on the main unit operate the same way as the main unit. The keys marked * are provided only on the remote control unit. 1 2 3 4 TIME DISP 1 4 7 CHECK 2 5 8 0 3 1 TIME DISPLAY key P. MODE # 5 Numeric keys ( 1 ~ ) , 0 ) 6 Basic function keys Skip keys (4, ¢) Search keys (1, ¡) Stop key (7) Play/Pause key (6) *7 OUTPUT (DOWN, UP) key # 11 6 9 +10 EDIT 5 CLEAR RANDOM REPEAT 2 Program-related keys P . MODE key EDIT key CLEAR key CHECK key 3 RANDOM key 4 REPEAT key $ * %( %( ) ^ # # @ @ 7 7 1 ¡ 4 DOWN 6 ¢ UP 6 7 OUTPUT LEVEL REMOTE CONTROL UNIT RC-P0715 Model: RC-P0715 Infrared ray system Loading batteries 1 Remove the cover. 3 Close the cover. 2 1 ÷ Insert two AA-size (R6) batteries as indicated by the polarity marking. Operation After plugging in the power cord, press the POWER switch of the main unit to turn the unit ON. When the unit is turned ON, press the key of the function to be operated. Remote control light sensor 6m 30º 30º 0 ÷ When pressing more than one remote control key successively, press the keys securely by leaving an interval of 1 second or more between keys. Operating range (Approx. ) Notes 1. [. . . ] (Sound is skipped. ) Play begins as soon as the unit is turned ON. ÷ This unit is designed so that play begins automatically when the unit is turned ON if a disc is already loaded. Remote control unit Symptom Remote control operation is not possible. Cause ÷ Batteries are exhausted. ÷ The remote control unit is too far away from the main system, controlling angle is too large, or there is an obstacle in between. Remedy !÷ Operate the remote control unit within the !controllable range. Specifications [ Format ] System . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]