User manual KENWOOD DPX-MP5070

[. . . ] Model DPX-MP5070/ DPX300U Serial number US Residents Only Register Online Register your Kenwood product at www. 14 About the Quick Start Guide This Quick Start Guide describes basic functions of this unit. For functions not described in this Guide, refer to the Instruction Manual on the following website: manual. ¤ CAUTION • Keep battery out of reach of children and in original package until ready to use. [. . . ] € If the fuse blows, first make sure the wires are not touching other parts to cause a short circuit, and then replace the old fuse with one with a new the same rating. € Insulate unconnected wires with vinyl tape or other similar materials. To prevent a short circuit, do not remove the caps on the ends of the unconnected wires and terminals. € Connect the speaker wires correctly to the corresponding terminals. The unit may be damaged or fail to work if you share the - wires or ground them to any metal part in the car. € When connecting only two speakers, connect the connectors either to both of the front output terminals or to both of the rear output terminals (do not mix front and rear terminals). For example, if you connect the + connector of the left speaker to a front output terminal, do not connect the connector to a rear output terminal. € After the installing the unit, check whether the brake lamps, blinkers, wipers, etc. € Mount the unit so that the mounting angle is 30° or less. To prevent a short circuit, remove the key from the ignition and disconnect the - battery. Make the proper input and output wire connections for each unit. The holes of the car bracket to use will differ depending on the car model. Using wrong screws might damage the unit. Installing Toyota Cars Install onto the car bracket using the screws (commercially available). Use the mounting holes (¦ in the illustration shown below) that fit the car bracket. Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach it in place. CONT When using the optional power amplifier, connect to its power control terminal. CONT Depending on what antenna you are using, connect either to the control terminal of the motor antenna, or to the power terminal for the booster amplifier of the film-type or short pole type antenna. (Max 300mA, 12V DC) Connect to the terminal that is grounded when either the telephone rings or during conversation. (DPX300U only) To connect the Kenwood navigation system, consult your navigation manual. Brown (Mute control wire) MUTE Orange/ White (Dimmer control wire) ILLUMI ⁄ To car light control switch Light Blue/ Yellow (Steering remote control wire) REMOTE CONT STEERING WHEEL REMOTE INPUT To use the steering wheel remote control feature, an exclusive remote adapter (not supplied) that matches your car is required. € Playable USB devices USB mass storage class • Playable USB device file systems FAT12, FAT16, FAT32 The online manual about audio files is put on the site, www. [. . . ] € Firefox is a registered trademark of Mozilla Foundation in the United States and other countries. € aha, the Aha logo, and the Aha trade dress are trademarks or registered trademarks of HARMAN International Industries, used with permission. • iHeartRadio® is a registered mark of Clear Channel Broadcasting , Inc. In the United States and other countries. [. . . ]