User manual KENWOOD DV-S701

[. . . ] DVD / VCD / CD PLAYER DV-S701 INSTRUCTION MANUAL KENWOOD CORPORATION This player has been designed to play back the DVD software which has been encoded for specific region areas. It cannot play back the DVD software encoded for other region areas than the region areas for which it has been designed. COMPACT COMPACT DIGITAL AUDIO DIGITAL VIDEO TEXT B60-4026-00 00 J (M2, T, E) MC 98 / 8 Introduction DV-S701 (En/E) 2 Before applying power Units are designed for operation as follows. Caution : Read this section carefully to ensure safe operation. This unit is intended for . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . AC 110-240 V Preparations For the United Kingdom Factory fitted moulded mains plug 1. For replacement, use only a 13-Amp ASTA-approved (BS1362) fuse. [. . . ] RC operation Example of instruction text in this manual. Illustration GRC operation (GRC-151, GRC-101 or GRC-102) Illustration of GRC operation in this manual Actual GRC operation 1 Select *** by using joystick. Press (select) the *** key. ENTER ENTER 2 Press the ENTER key. ENTER *1 P. MODE Press (select) the P. MODE key. F4 ENTER 1 Select the "F4" icon. ÷ When using the GRC, you can return to the previous menu screen (level) at any time by selecting the Return icon, and the ENTER key. P. mode ENTER *1: Icons without shading send you to another menu screen (level) for the next operation. At the new screen, you can select the desired icon. Other Operations Preparations DVD Mode (Scan) Repeat RepeatA-B Scan / Skip Stereo Text Karaoke DVD Mode (Skip) Repeat RepeatA-B Scan / Skip Stereo Text Karaoke 10key Pad (DVD) 123 Enter Clear 456 789 0 Graphical remote control unit (GRC unit) DV-S701 (En/E) 24 Once the settings have been made in Steps 1 to 4, you do not need to repeat these steps until you replace the batteries. The GRC beginning on page 25 are written assuming that the basic operations below have been completed. Preparation Turn the system devices ON. Basic Operations for the Graphical Remote Control Unit (GRC) At the be used. 1 thethe initial screen, selecthaveModel Type to made. ) (You may skip if the settings for AV CONTROL CENTER already been 1 Preparations 1 Use the joystick to select the model type. Example: For more information about the Model Type settings, please refer to the instructions accompanying the AV CONTROL CENTER (sold separately) or the receiver (sold separately). Select Main Menu Return Confirm CD Tuner TapeA TapeB TV VCR1 VCR2 ENTER Model 4 2 Screen after selection Main Menu Return Confirm CD Tuner TapeA TapeB TV VCR1 VCR2 DVD MD LD Tape1 Cable Sat. Set Up DVD MD LD Tape1 Cable Sat. Set Up 2 Press the ENTER key to set the entry. Model Type Setup Model 1 Model 2 Model 3 Model 4 Model 5 Model 6 Setup CD Sat. L D Tape1 VCR1 TV Cable VCR2 MD Reset DVD/6ch Input Sound Speaker Operations Other The arrow ( ) shows the direction that the cursor moves when selecting icons. ÷ The selected icon is highlighted. 2 Select DVD/6ch Input at the Setup menu screen. (C-V550, C-V700 and C-V750 only) 1 1 Use the joystick to select the DVD/ 6ch Input icon. Select Main Menu Return Confirm CD Tuner TapeA TapeB TV VCR1 VCR2 Screen after selection Main Menu Return Confirm CD Tuner TapeA TapeB TV VCR1 VCR2 DVD MD LD Tape1 Cable Sat. Set Up DVD MD LD Tape1 Cable Sat. Set Up ENTER DVD/6ch Input 2 Setup CD Sat. Setup DVD / 6ch Input LD TV Tape1 VCR1 Cable VCR2 MD Reset DVD 6ch Input DVD/6ch Input 2 Press the ENTER key to set the entry. Sound Speaker 3 Select DVD or 6ch Input at the DVD/6ch Input menu screen. (C-V550, C-V700 and C-V750 only) 1 1 Use the joystick to select the DVD or 6ch Input icon. Select TapeA Screen after selection CD Tuner TapeA TapeB TV Main Menu Return Confirm CD Tuner TapeB TV VCR1 VCR2 Main Menu Return Confirm VCR1 VCR2 DVD MD LD Tape1 Cable Sat. Set Up DVD MD LD Tape1 Cable Sat. Set Up ENTER Setup DVD / 6ch Input Setup DVD / 6ch Input DVD 6ch Input DVD 2 6ch Input or DVD 6ch Input 2 Press the ENTER key to set the entry. 4 Select DVD at the Segment screen. 1 ÷ The DVD analog input of the AV CONTROL CENTER (sold separately) can be switched between 2-channel (DVD) or 6-channel input. ÷ If "6ch Input" is selected, the output from the AV CONTROL CENTER (sold separately) cannot be recorded on a recording component. 1 Use the joystick to select the DVD icon. DVD Select Main Menu Return Confirm CD Tuner TapeA TapeB TV VCR1 VCR2 Screen after selection Main Menu Return Confirm CD Tuner TapeA TapeB TV VCR1 VCR2 DVD MD LD Tape1 Cable Sat. Set Up DVD MD LD Tape1 Cable Sat. Set Up ENTER Setup DVD / 6ch Input DVD DVD (Scan) 10key Mode Ret. F4 2 2 Press the ENTER key to set the entry. 6ch Input Skip F1 F2 F3 Playback DV-S701 (En/E) The following procedure shows how to play a disc, such as a CD, VCD or DVD, from the beginning. (Play-Back Control) capability, please read "Menu playback". , 25 Preparation Press the POWER key to ON. Main unit POWER - ON ­ OFF 1 Turn power ON. When using the system connections: 1 Turn on the AV CONTROL CENTER (sold separately) or the receiver (sold separately). ÷ Read also the instruction manual supplied with the AV CONTROL CENTER (sold separately) or the receiver (sold separately). When not using the system connections: Press the ON/STANDBY ( Main unit ) key to ON. 2 Switch to DVD operation. ÷ Playback will start if a disc is already loaded. ON / STANDBY Main unit 1 Open the tray. RC Label side up OPEN /CLOSE 0 For CD single (8 cm) or DVD single (8 cm) Other disc (12 cm) 0 2 Insert (Remove) the disc. 3 Close the tray. OPEN /CLOSE 0 Disc tray 0 3 Start playback. Main unit RC GRC Display during disc play CD playback DVD VCD CD P. B. C. DOLBY DIGITAL VCD playback DVD VCD CD P. B. C. DOLBY DIGITAL DVD playback DVD VCD CD P. B. C. DOLBY DIGITAL 3 3 ENTER TITLE CHAPTER TRACK TITLE CHAPTER TRACK TITLE CHAPTER TRACK 01 01 01 Other With certain discs, playback starts now. If a menu screen appears on the TV screen, select the desired items as described in steps 4 and 5 before playing the disc. ÷ Place the disc to be played properly by aligning it with the groove on the tray. (If the disc is not placed horizontally, malfunction will result. ) ÷ Do not touch the played side. ÷ This unit cannot use a commercially available CD single (8 cm) disc adapter. Operations 2 Insert (Remove) the disc. Preparations Playing a disc from the beginning Playback DV-S701 (En/E) 26 4 Select the desired items from the menu screen. Menu screen: When an interactive DVD (DVD software containing multiple viewing angles or stories, for example) or a P. B. C. compatible VIDEO CD is played, a menu screen is displayed in the beginning. Example: Menu screen of a DVD with menu recording TITLE MENU Dogs Lovers Castles Birds ÷ The display, operation method and usable keys of the menu screen are variable depending on software. For details, read the instructions provided with the played software. Preparations RC GRC TITLE MENU Dogs Lovers Castles Birds \ Selection using cursor (%, fi, @, #) keys (DVD only) F1 ENTER Birds of the world Menu ENTER ENTER ENTER ÷ When the menu has a hierarchical structure, the menu at the lower level appears. [. . . ] MPEG-1 DVD . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . MPEG-2 Composite video output level . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . negative) S-video output level (Y-signal) . . . . . . . . . . . . . . . . . . . . . . . . . negative) (C-signal) PAL . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ]